Echo CS-3700ES Service Data

Other manuals for CS-3700ES: Operator's Manual

Summary of CS-3700ES

  • Page 1

    Cs-3700es, cs-4200es 01-36c-01 1 introduction we are constantly working on technical improvement of our products. For this reason, technical data, equipment and design are subject to change without notice. All specifications, illustrations and directions in this service data are based on the latest ...

  • Page 2

    Service information cs-3700es cs-4200es 2 1 service information 1-1 specifications model cs-3700es cs-4200es dimensions length* mm(in) 383 (15.1) width mm(in) 238 (9.4) height mm(in) 270 (10.6) dry weight* kg(lb) 4.4 (9.7) engine type kioritz, air-cooled, two-stroke, single cylinder ventilated pisto...

  • Page 3

    Service information cs-3700es cs-4200es 3 1-2 technical data model cs-3700es cs-4200es engine idling speed r/min 2300 - 3000 operating speed* r/min 8500 - 9000 high speed (no load full throttle)* r/min 11500 - 12500 clutch engagement speed* r/min 3500 - 4300 compression pressure mpa (kgf/cm 2 ) (psi...

  • Page 4

    Service information cs-3700es cs-4200es 4 1-3 torque limits descriptions size kgf•cm n•m in•lbf starter starter pawl m 5* 40 - 60 4 - 6 35 - 50 system starter case m 4 10 - 20 1 - 2 9 - 18 ignition magneto rotor (flywheel) m 8 200 - 240 20 - 24 175 - 210 system ignition coil m 5 50 - 75 5.0 - 7.5 45...

  • Page 5

    Service information cs-3700es cs-4200es 5 5k177 5k177 5k083 5k084 5k081 5k082 5k016 5k025 5k174 5k178 5k173 1 2 3 4 5 6 7 5k171 5k191b 1-5 service limits mm (in) a cylinder bore when plating is worn and aluminium can be seen b piston outer diameter min. 38.91 (1.53) 40.94 (16.12) c piston pin bore m...

  • Page 6

    Service information cs-3700es cs-4200es 6 1.35 0.4 1.65 1.5 a 20 20 40 40 60 60 80 80 12 0 120 140 140 16 0 160 180 180 20 20 100 100 91 01 9 1-6 special tools 1 4 5 2 6 9 10 11 13 12 14 15 16 19 3 8 key part number description used for: 1 897801-33330 tachometer pet-1000 measuring engine speed to a...

  • Page 7

    Service information 7 cs-3700es cs-4200es h l b a a b 2 emission adjustment guide 2-1 general adjusting rules a. Before starting the unit for adjustment, check the following items. 1. The correct spark plug must be clean and properly gapped. 2. The air filter element must be clean and properly insta...

  • Page 8

    Service information 8 cs-3700es cs-4200es 2-2 presetting idle adjust screw, l mixture needle and h mixture needle (continued) 2. Screw threaded end of limiter cap tool 91019 with 2.5 mm left-hand thread into center hole of limiter cap anticlockwise until tab of the limiter cap just comes out of the ...

  • Page 9

    Service information 9 cs-3700es cs-4200es h l a b b a h mixture needle l mixture needle idle adjust screw c 2-3 adjusting carburetor 1. Start engine and warm it up at idle for one minute. Turn h mixture needle anticlockwise until engine speed drops to approx. 11,000 r/min. 2. Warm it up well for 100...