Echo CS-440 Instruction Manual - Chain Lubricant

13

CS-440

OIL TANK CAP

FUEL TANK CAP

CAP INDICATION

Fuel/oil tanks are indicated by the following

illustrations.

CHAIN LUBRICANT

Proper lubrication of the chain while in operation

reduces friction between the chain and the guide

bar to a minimum and assures a longer service life.

• Use bar and chain oil of high quality for this

purpose.

• Do not use used or reclaimed oil to avoid various

oiler problems.

• Use ECHO bar and chain oil.

• When ECHO bar and chain oil is not available:

Use motor oil, etc.

• Use bar and chain oil of the following grades:

SAE No. 30 ....... in summer

SAE No. 10 ....... in winter or when cutting

resinous trees.

• When refueling, also refill chain oil.

WHEN THE ENGINE IS COLD

   CAUTION

Make sure the bar and chain are free from

any obstruction when starting the chain saw.

• Move chain brake lever fully forward to lock chain

brake before starting.

• Fill the fuel tank with fuel mixture.

It is not permitted to fill fuel above the shoulder

level of fuel tank.

• Fill the chain oil tank with lubricant.

Do not over fill.

• Move ignition switch to “RUN” position.

• Pull choke control knob all the way out. (Choke

position)

• Securely hold the chain saw as shown and pull

starter handle several times until first firing

sound.

• Push choke control knob all the way in.

• Pull starter handle to start the engine.

• After starting the engine, pull front hand guard

towards the operator immediately. (Chain brake

unlocked position)

OPERATION

CHOKE

Choke control knob

START/RUN

Ignition switch

Chain brake

Starter handle

Unlock chain brake