- DL manuals
- Echo
- Chainsaw
- CS-510
- Instruction Manual
Echo CS-510 Instruction Manual
Summary of CS-510
Page 1
Instruction manual echo chain saw cs-510 warning danger read instructions carefully and follow rules for safe operation. Failure to do so could result in serious injury..
Page 2
The engine exhaust from this product contains chemicals known to the state of california to cause cancer, birth defects or other reproductive harm. Warning.
Page 3: Rules For Safe Operation
1 1.Do not operate a chain saw with one hand! Serious injury to the operator, helpers, bystanders, or any combination of these persons may result from one-handed operation. A chain saw is intended for two-handed use. 2.Do not operate a chain saw when you are fatigued. Rules for safe operation a. Kic...
Page 4
2 5.Do not allow other persons to be near the chain saw when starting or cutting with the chain saw. Keep bystanders and animals out of the work area. 6.Do not start cutting until you have a clear work area, secure footing, and a planned retreat path from the falling tree. 7.Keep all parts of your b...
Page 5: Contents
3 contents this symbol accompanied by the words warning and danger calls attentions to an act or a condition which can lead to serious personal injury or death. Rules for safe operation ............................................................................. 1 nomenclature have parts .............
Page 6: Nomenclature Have Parts
4 nomenclature have parts 6 5 8 9 10 11 12 13 14 21 16 17 18 20 4 19 1 2 3 15 7.
Page 7: Nomenclature Have Parts
5 nomenclature have parts 1. Instruction manual - included with unit. Read before operation and keep for future reference to learn proper, safe operating techniques. 2. Installation and use kick guard - describe how to install the kick guard and operate the saw with kick guard. 3. Safety manual - de...
Page 8: Hot Humid Weather
6 hot humid weather • heavy protective clothing can increase operator fatigue which may lead to heat stroke. Schedule heavy work for early morning, or late afternoon hours when temperatures are cooler. Vibration and cold • it is believed that a condition called raynaud’s phenomenon, which affects th...
Page 9: Spark Arrestor Muffler
7 spark arrestor muffler • the spark arrestor muffler controls the exhaust noise and prevents hot, glowing particles of carbon from leaving the muffler. Make sure the spark arrestor screen is in good repair and properly seated in the muffler. • certain internal combustion engines operated on forest,...
Page 10: Preparation For Use
8 preparation for use bar hole clutch cover adjusting screw note ensure that the chain is installed with the cutters directed forward on the top of the bar. Caution • all adjustment, should be made cold. • always wear gloves when working on chain. Proper tension improper tension mounting guide bar a...
Page 11: Fuel Statement
9 oil gas oil gas gal fl oz l ml 1 2 5 2.6 5.1 12.8 4 8 20 80 160 400 (metric) (us) 50 : 1 oil tank cap fuel tank cap cap indication fuel/oil tanks are indicated by the following illustrations oil gasoline 50 1 fuel statement gasoline-use 89 octane [ ] gasoline or gasohol known to be good quality. G...
Page 12: Operation
10 operation when the engine is cold • fill the fuel tank with fuel. • fill the chain oil tank with lubricant. • press hand guard forward. (chain brake activated position) • turn ignition switch upside. (“run” position) • pull choke control knob all the way out. (choke position) caution make sure ba...
Page 13: Running
11 running • when engine starts, keep idling for a few minutes. • pull throttle trigger gradually and increase revolution of the engine. • the chain starts running when the engine reaches to 3,800 r/min approximately. • confirm proper acceleration and lubrication of chain and bar. Stopping • release...
Page 14: Cutting Instruction
12 cutting instruction general note read the echo “chain saw safety manual” included with your chain saw for additional cutting and safety instructions. In all circumstances the operation of the chain saw is a one-man job. It is difficult at times to take care for your own safety, so don’t assume th...
Page 15: Falling The Tree
13 falling the tree a falling tree can seriously damage anything it may hit - a car, a house, a fence, a power line, or another tree. There are ways to make a tree fall where you want it, so first decide where that is! Before cutting, clear the area around the tree. You will need good footing while ...
Page 16: Bucking
14 caution wear suitable hearing protective device such as earmuffs or earplugs to protect against objectionable or uncomfortable loud noises. Don’t cut with the saw overhead or the bar in a vertical position. If the saw should kick back, you may not have well enough control to prevent possible inju...
Page 17: Chain Brake Operation
15 chain brake operation • set the lever in the released position before starting to cut. • if the brake is tripped by kick back reaction, the chain will stop immediately release the throttle to avoid possible damage prevent to the engine or clutch. • do not attempt to operate the engine with the br...
Page 18: Automatic Chain Brake
16 end of the guide bar may be placed at the height of about 35 cm. 35 cm automatic chain brake the automatic chain brake stops the operation of the saw chain in such a manner that kick-back action produced at the end of the guide bar automatically actuates the chain brake. To make sure that the aut...
Page 19: Maintenance and Care
17 maintenance and care carburettor adjustment every unit is run at the factory and the carburettor is set in compliance with california emission regulations. In addition, the carburettor is equipped with “h” (high speed needle) and “l” (low speed needle) needle adjustment limited that prevent setti...
Page 20: Air Filter
18 cleaner cover knob spark plug air cleaner cover air filter cylinder cover air filter cover air filter • check before every use. • loosen cleaner cover knob and remove air cleaner cover and filter. • brush off dust lightly, or clean with compressed air, or replace the air filter. • reinstall filte...
Page 21: Fuel Strainer
19 fuel strainer • check periodically. • do not allow dust to enter fuel tank. • clogged strainer will cause difficulty in starting engine or abnormalities in engine performance. • pull the fuel strainer out through fuel inlet port with a piece of steel wire or the like. • when the strainer is dirty...
Page 22: Setting The Saw Chain
20 setting the saw chain sprocket • the damaged sprocket will cause premature damage or wear of saw chain. - when the sprocket has worn out 0.5 mm (0.020 in) or more, replace it. • check sprocket when you install new chain. Replace it if worn. Guide bar • clean before using. - clean the groove of th...
Page 23: Setting Saw Chain
21 setting saw chain • for setting saw chain, round file (4 mm dia. 5/32 inch) and flat file are used. • to keep correct position and correct angle, use the file holder (sure sharp). - round file (p-no. 897510-03931) and flat file (p-no. 897511-00230) are optional. - inquire about the file holder, i...
Page 24: Saw Chain
22 @ 406 (16) 160336601 162336601 8.26 (0.325) oregon33sl 66 457 (18) 180337201 182337201 8.26 (0.325) oregon33sl 72 508 (20) 200337801 202337801 8.26 (0.325) oregon33sl 78 chain and guide bar combination guide bar saw chain the following combinations are recommended to the model cs-510. Side plate ...
Page 25: Service Guide
23 service guide area maintenance page air filter clean • replace 18 • fuel filter clean replace 19 • spark plug clean • replace 18 • carburettor check/rebuild • replace 17 1 • cooling system inspect/clean 18 • muffler inspect/clean - • oil filter inspect/replace 19 • sprocket inspect/replace 20 • s...
Page 26: Trouble Shooting
24 problem engine starts hard cause remedy does not start engine fuel at no fuel • fuel strainer clogged • clean cranks carburettor at carburettor • fuel line clogged • clean • carburettor • ask your echo dealer fuel at no fuel at • carburettor • ask your echo dealer cylinder cylinder muffler wet • ...
Page 27: Storage After Use
25 cs - 510 dimension l x w x h mm 398 x252x 272 (15.7 in x 9.9 in x 10.7 in) masses power head, dry kg 4.9 (10.8 lb) without chain and guide bar engine type air-cooled two-stroke single cylinder displacement ml (cm³) 49.3 (3.00 cu in) carburettor diaphragm type magneto flywheel magneto : cdi system...
Page 28
Usa x750-001 75 0 x750319 - 4400 echo, incorporated 400 oakwood road, lake zurich, illinois 60047-1564 phone : 847-540-8400