1. DL manuals
  2. Echo
  3. Paper Shredder
  4. ES-2100ESL
  5. Operator's Manual

Echo ES-2100ESL Operator's Manual

Manual is about: LEAF SHREDDER

Summary of ES-2100ESL

  • Page 1

    Operator's manual es-2100esl leaf shredder warning, read operator's manual x7531138201 08/10

  • Page 2

    2 introduction warning danger read and understand the rules for safe operation and all instructions in this manual. Wear eye and hearing protection. Improper use or care of this unit, or failure to wear proper protection can result in serious injury. The echo es-2100esl shred-n-vac™ are lightweight,...

  • Page 3

    3 rules for safe operation warning danger users risk injury to themselves and oth- ers if the unit is used improperly, and/or safety precautions are not followed. Proper clothing and safety gear must be worn when operating this unit. Operator safety • read this manual carefully. Be sure you understa...

  • Page 4

    4 hot humid weather heavy protective clothing can increase operator fatique which may lead to heat stroke. Delay heavy work until the temperature drops. Vibration and cold it is believed that a condition called raynaud's phenom- enon, which affects the fingers of certain individuals may be brought a...

  • Page 5

    5 contents 1 - power head 1 - blower pipe assembly 1 - shred 'n' vac suction tube 1 - vacuum bag 1 - operator's manual 1 - t-wrench 9 1 3 4 5 10 12 13 16 15 14 6 7 11 7 2 8 17 15 5 p/n 89016006361 p/n 89016009461 description s afety decals locate these safety decals on your unit. Make sure the decal...

  • Page 6

    6 1. Spark plug - provides spark to ignite fuel mixture. 2. Throttle position lever - pull back to increase engine speed. Friction washers maintain throttle trig- ger setting. 3. Silencer/spark arrester - the spark arrester muffler controls the exhaust noise while the spark ar- rester prevents hot, ...

  • Page 7

    7 assembling warning danger never perform maintenance or assem- bly procedures with engine running. Note never operate unit without either fan grid and blower pipes or vacuum tube with vaccum elbow and debris bag are installed securely on the unit. Installing vacuum tube for vacuum us- age 1. Turn k...

  • Page 8

    8 installing blower pipes for blower usage 1. Remove tube retaining screw from blower housing. Align grooves in straight pipe with pegs of blower housing and slide pipe onto housing. 2. Turn straight pipe clockwise to lock it into place. 3. Tighten screw securely. 4. Remove tube retaining screw from...

  • Page 9

    9 minimum 3 m • never store the unit with fuel in the tank - a fuel leak could start a fire. • store fuel in a well ventilated, unoccupied building away from sparks and flames. Note stored fuel ages. Do not mix more fuel than you expect to use in thirty (30) days. Do not mix directly in fuel tank. H...

  • Page 10

    10 operating vacuum warning danger • always wear safety glasses and use a face filter mask. (read the safe operation carefully.) • do not point vacuum tube in the direction of people or pets. Note do not block vacuum pipe to avoid engine damage due to over speed. Note never use a higher speed settin...

  • Page 11

    11 reduce chances of damage • before starting the job, check wind direction. Avoid blow- ing in the direction of open doors and windows, cars, pets, children or anything that could be harmed by blowing dust, leaves and debris. • use the full nozzle extension so the air stream is close to the ground....

  • Page 12

    12 final adjustment important limiter caps prevent exceeding emission limits and over rich adjustment, but not over lean adjustment, which can cause engine failure: do not exceed rec- ommended high speed engine rev during operation, or for long periods during adjustment. 1. Start engine, run at idle...

  • Page 13

    13 spark plug 1. Check plug gap. Correct gap is 0.6 - 0.7 mm. 2. Inspect electrode for wear. 3. Inspect insulator for oil or other deposits. 4. Replace plug if needed and tighten to 15 - 17 n·m (150 to 170 kgf·cm). Note do not overtighten spark plug. 0.6 - 0.7 mm cooling system maintenance note to m...

  • Page 14

    14 replacing fuel filter note a clogged fuel filter will cause hard starting or poor engine performance. 1. Pick up the fuel filter through fuel tank opening with a piece of steel wire or the like. 2. Remove old filter from fuel line. 3. Install new fuel filter. Note keep fuel tank clean - do not al...

  • Page 15

    15 troubleshooting trouble engine - starts hard cause remedy - does not start engine fuel at no fuel • fuel filter clogged • clean or replace. Cranks carburettor at carburettor • fuel line clogged • clean. • carburettor • ask your echo dealer. Fuel at no fuel at • carburettor • ask your echo dealer....

  • Page 16

    16 long term storage (over 60 days) do not store your unit for a prolonged period of time (60 days or longer) without performing protective storage main- tenance which includes the following: 1. Store unit in a dry, dust-free place, out of the reach of children. Warning danger do not store in enclos...

  • Page 17

    17 es-2100 dimensions : length x width x height mm 330 x 285 x 340 mass kg 4.3 engine : type air cooled two stroke single cylinder engine displacement ml (cm 3 ) 21.2 carburetor zama diaphragm model ciu type with purge ignition flywheel magneto - cdi system spark plug ngk bpmr7a starter automatic re...

  • Page 18

    18 n otes.

  • Page 19

    19 n otes.

  • Page 20: Yamabiko Corporation

    7-2 suehirocho 1-chome, ohme, tokyo, 198-8760, japan phone: 81-428-32-6118 fax: 81-428-32-6145 yamabiko corporation © 2010 yamabiko corporation p32024001001/p32024999999.