1. DL manuals
  2. Echo
  3. Trimmer
  4. GT-200R - SERIAL NUMBER 07001001-07003100
  5. Operator's Manual

Echo GT-200R - SERIAL NUMBER 07001001-07003100 Operator's Manual

Summary of GT-200R - SERIAL NUMBER 07001001-07003100

  • Page 1

    Grass trimmer operator's manual model gt-200r serial number 07001001 - 07003100 warning danger read rules for safe operation and instructions carefully. Echo provides an operator's manual and a safety manual. Both must be read and understood for proper and safe operation. X770000701 10/03 x770227730...

  • Page 2

    2 i ntroduction welcome to the echo family. This echo product was designed and manufactured to provide long life and on-the- job-dependability. Read and understand this manual and the safety manual you found in the same package. You will find both easy to use and full of helpful operations tips and ...

  • Page 3

    G rass t rimmer o perator ' s m anual 3 s afety decals locate these safety decals on your unit. The complete unit illustration found in the "description" section, will help you locate them. Make sure the decals are legible and that you understand and follow the instructions on them. If a decal canno...

  • Page 4: Warning

    4 p/n 89031744530 shaft decal • this unit can be dangerous and cause serious injury if improperly used. To reduce injury risk to operator, helpers and bystanders, read and understand the operator's and safety manuals. • blindness can occur from objects that are thrown or ricocheted even with shield ...

  • Page 5

    G rass t rimmer o perator ' s m anual 5 s afety i nstructions personal condition and safety equipment warning danger trimmer/brush cutter users risk injury to themselves and others if the trimmer/brush cutter is used improperly and or safety precautions are not followed. Proper clothing and safety g...

  • Page 6: Warning

    6 safe operation warning danger do not operate this product indoors or in inadequately ventilated areas. Engine exhaust contains poisonous emissions and can cause serious injury or death. Read the manuals • provide all users of this equipment with the operator's manual and safety manual for instruct...

  • Page 7

    G rass t rimmer o perator ' s m anual 7 d escription the echo product you purchased has been partially assembled for your convenience. Due to packaging restrictions, installation of the plastic debris shield, nylon line head, and positioning of the front handle are necessary. After opening the carto...

  • Page 8

    8 10 11 13 14 15 16 17 18 12 1 3 4 5 6 7 8 2 9 19.

  • Page 9

    G rass t rimmer o perator ' s m anual 9 1. Power head - factory assembled to the driveshaft assembly. Includes the engine, clutch, fuel system, ignition system and recoil starter. 2. Grip - rear (right hand) handle. 3. Front handle - the front (loop) handle is factory assembled to the drive shaft as...

  • Page 10

    10 s pecifications model ------------------------------------------ gt-200r length -------------------------------------------- 1400 mm (55.1 in.) width --------------------------------------------- 310 mm (12.2 in.) height -------------------------------------------- 385 mm (15.2 in.) weight (dry) ...

  • Page 11

    G rass t rimmer o perator ' s m anual 11 a ssembly tools required: locking tools (2), wrench 17 x 14.5 (9/16 in.) parts required: rapid loader tm head, large washer, small washer, 3/8-24 locknut, (2) pre-cut nylon line 8 in. X .080 in. C a b plastic shield installation 1. Remove wing nut (a), washer...

  • Page 12

    12 a b front ( loop ) handle note front handle is pre-installed. Re-positioning and tightening is all that is required. 1. Position front handle (a) in comfortable operating position and tighten wing nut (b). The cutting attachment should be 5-7.5 cm (2-3 in.) above the ground and as level as possib...

  • Page 13: - O

    G rass t rimmer o perator ' s m anual 13 p re - o peration fuel fuel requirements gasoline - use 89 octane [ ] (mid grade or higher) gasoline known to be good quality. Gasoline may contain up to 15% mtbe (methyl tertiary-butyl ether). Gasohol containing methyl (wood) alcohol is not approved. Two str...

  • Page 14: Warning

    14 o peration starting cold engine warning danger the attachment will operate immediately when the engine starts and could result in loss of control and possible serious injury. Keep movable parts of the attachment off the ground and away from objects that could become entangled or thrown. 1. Stop s...

  • Page 15: Warning

    G rass t rimmer o perator ' s m anual 15 starting warm engine the starting procedure is the same as cold start except do not close the choke, and do not depress throttle trigger to wide open position. Warning danger the attachment should not move at idle, otherwise serious personal injury may result...

  • Page 16

    16 m aintenance your echo trimmer is designed to provide many hours of trouble free service. Regular scheduled maintenance will help your trimmer achieve that goal. If you are unsure or are not equipped with the necessary tools, you may want to take your unit to an echo service dealer for maintenanc...

  • Page 17: Warning

    G rass t rimmer o perator ' s m anual 17 air filter level 1. Tools required: 25 or 50 mm (1 or 2 in.) cleaning brush parts required: 90008 repower tm air & fuel filter kit. 1. Close choke (cold start position [ ]). This prevents dirt from entering the carburetor throat when the air filter is removed...

  • Page 18

    18 0.65 mm (0.026 in.) spark plug level 2. Tools required: spark plug socket wrench and screw driver, feeler gauge, soft wire brush. Parts required: spark plug, ngk bpmr-8y p/n a425000000 1. Remove spark plug and check for fouling, worn and rounded center electrode. 2. Clean the plug or replace with...

  • Page 19: Warning

    G rass t rimmer o perator ' s m anual 19 important do not use a metal scraper to remove dirt from the cylinder fins. 4. Use the brush to remove dirt from the cylinder fins. 5. Remove grass and leaves from the grid between the recoil starter and fuel tank. 6. Assemble components in reverse order. Not...

  • Page 20: Warning

    20 cylinder exhaust port level 3. Important the cylinder exhaust port must be inspected and cleaned of excess carbon every 3 months or 90 hours of operation in order to maintain this engine within the emissions durability period. Echo strongly recommends that you return your unit to your echo dealer...

  • Page 21

    G rass t rimmer o perator ' s m anual 21 lubrication level 1. Tools required: 8mm open end wrench, screwdriver, clean rag. Parts required: echo ® lube tm 8 oz. (p/n 91014) or lithium base grease. 1. Remove plastic shield. 2. Loosen bearing housing locating screw (a), at the top of the housing, loose...

  • Page 22: Warning

    22 t roubleshooting warning danger fuel vapors are extremely flammable and may cause fire and/or explosion. Never test for ignition spark near an open spark plug opening, otherwise serious personal injury may result. T r a h c g n i t o o h s e l b u o r t m e l b o r p e n i g n e m e l b o r p k c...

  • Page 23: Warning

    G rass t rimmer o perator ' s m anual 23 s torage long term storage (over 30 days) warning danger during operation the muffler or catalytic muffler and surrounding cover become hot. Always keep exhaust area clear of flammable debris during transportation or when storing, otherwise serious property d...

  • Page 24

    S ervicing i nformation parts genuine echo parts and echo repower™ parts and assemblies for your echo products are available only from an authorized echo dealer. When you do need to buy parts always have the model number, type and serial number of the unit with you. You can find these numbers on the...