Echo GT-220ES Service Data

Summary of GT-220ES

  • Page 1

    Gt-220es, srm-220es 10-21p-02 1 introduction we are constantly working on technical im- provement of our products. For this reason, technical data, equipment and design are subject to change without notice. All speci- fications, illustrations and directions in this service data are based on the late...

  • Page 2

    Service information gt-220es srm-220es 2 1 service information 1-1 speci fi cations model gt-220es srm-220es (l) srm-220es (u) dimensions length* mm(in) 1460 (57.4) 1760 (69.3) width mm(in) 320 (12.6) 345 (13.5) 655 (25.7) height mm(in) 575 (22.6) 320 (12.6) 420 (16.5) dry weight * kg(lb) 4.4 (9.7) ...

  • Page 3

    Service information gt-220es srm-220es 3 1-2 technical data model gt-220es srm-220es (l) srm-220es (u) engine idling speed r/min 2600 - 3400 wide open throttle speed r/min 7000 - 8000* 8000 - 9700* 9500 - 11500** clutch engagement speed r/min 3500 - 4100 compression pressure mpa (kgf/cm 2 ) (psi) 0....

  • Page 4

    Service information gt-220es srm-220es 4 1-3 torque limits descriptions size kgf•cm n•m in•lbf starter starter case m 4 14 - 28 1.4 - 2.8 12 - 24 system ignition ignition coil m 4 30 - 50 3 - 5 26 - 45 system fan cover m 4** 14 - 28 1.4 - 2.8 12 - 24 spark plug m 14 150 - 170 15 - 17 130 - 150 groun...

  • Page 5

    Service information gt-220es srm-220es 5 description mm (in) a cylinder bore when plating is worn and aluminium can be seen b piston outer diameter min. 32.10 (1.264) c piston pin bore max. 8.030 (0.3161) d piston ring groove max. 1.6 (0.063) e piston ring side clearance max. 0.1 (0.004) f piston pi...

  • Page 6

    Service information gt-220es srm-220es 6 ignition air gap gauge #.014 = .35mm p/n 91004 echo 0 0.4 50 0.8 1.2 1. Mpa 0 key part number description used for: 1 897801-33330 tachometer pet-1000 measuring engine speed 2 363018-00310 washer installing crankcase oil seal of starter side 3 895610-79920 l-...

  • Page 7

    Service information gt-220es srm-220es 7 2 carburettor adjustment procedure 2-1 general adjusting rules a. Before starting the unit for adjustment, check the following items. 1. The correct spark plug must be clean and properly gapped. 2. The air fi lter element must be clean and properly installed....

  • Page 8

    Service information gt-220es srm-220es 8 2-3 adjusting carburettor 1. Start and warm up engine alternating engine speed between wot for 10 seconds and idle for 5 seconds for 3 minute. Note : if the engine can’t start, turn idle mixture needle clockwise in 1/4 turn increments until the engine starts....