1. DL manuals
  2. Echo
  3. Trimmer
  4. HC-235
  5. Operator's Manual

Echo HC-235 Operator's Manual

Other manuals for HC-235: Operator's Manual
Manual is about: Hedge Clipper

Summary of HC-235

  • Page 1

    Warning read rules for safe operation and all instructions carefully. Echo provides this operator's manual and a safety manual. Both must be read and under- stood for proper and safe operation. Hedge clipper operator's manual model hc-245 x7502256103 x750010633 01/10

  • Page 2: ’

    2 maintenance .................................................................14 - skill levels ...........................................................14 - maintenance intervals ...........................................15 - air filter .............................................................

  • Page 3

    H edge c lipper 3 o perator ' s m anual caution the safety alert symbol accompanied by the word “caution” calls attention to an act or condition which may lead to minor or moderate personal injury if not avoided. International symbols s afety manual safety symbols and important information symbol de...

  • Page 4

    4 physical condition your judgment and physical dexterity may not be good: • if you are tired or sick, • if you are taking medication, • if you have taken alcohol or drugs. Operate unit only if you are physically and mentally well. Eye protection wear eye protection that meets ansi z87.1 or ce re- q...

  • Page 5

    H edge c lipper 5 o perator ' s m anual danger do not operate this product indoors or in inadequately ventilated areas. Engine exhaust contains poisonous emissions and can cause serious injury or death. Read the manuals • provide all users of this equipment with the operator’s manual and safety manu...

  • Page 6

    6 equipment check warning use only echo approved attachments. Serious injury may result from the use of a non-approved attachment combi- nation. Echo, inc. Will not be responsible for the failure of cutting devices, attachments or accessories which have not been tested and approved by echo. Read and...

  • Page 7

    H edge c lipper 7 o perator ' s m anual 6 7 8 9 10 11 12 13 14 15 p/n x505000270 p/n x505000280 right front handle guard p/n 89016006361 hot decal (near muffler) d escription locate the safety decals on your unit. Make sure the decals are legible and that you understand and follow the instruc- tions...

  • Page 8

    8 1. Blades - double reciprocating single side blades mounted to a blade support bar. 2. Support handle with guard - for right hand - rubber non-slip grip, guard protects hand from the blades. Warning decals are located on guard. 3. Spark plug - provides spark to ignite fuel mixture. 4. Purge bulb -...

  • Page 9

    H edge c lipper 9 o perator ' s m anual c ontents the echo product you purchased has been factory pre-assembled for your convenience. After opening the carton, check for damage. Immediately notify your retailer or echo dealer of damaged or missing parts. Use the contents list to check for missing pa...

  • Page 10

    10 o peration warning moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects away from all openings. Always stop engine, disconnect spark plug, and make sure all moving parts have come to a complete stop before removing obstructions, clearing debris, or se...

  • Page 11

    H edge c lipper 11 o perator ' s m anual mixing instructions 1. Fill an approved fuel container with half of the required amount of gasoline. 2. Add the proper amount of 2-stroke oil to gasoline. 3. Close container and shake to mix oil with gasoline. 4. Add remaining gasoline, close fuel container, ...

  • Page 12

    12 starting cold engine warning hedge clipper blades are very sharp. Touching them may lead to severe personal injury. Avoid touching blades whenever possible, and always wear gloves to protect hands. Note the blade cover is used for transportation and storage. Remove blade cover before using the un...

  • Page 13

    H edge c lipper 13 o perator ' s m anual stopping engine 1. Throttle release throttle and allow engine to return to idle before shutting off engine. 2. Stop switch move stop switch (a) to stop position. Warning if engine does not stop when stop switch is moved to stop posi- tion, close choke - cold ...

  • Page 14

    14 warning hedge clipper blades are very sharp. Touching them may lead to severe personal injury. Avoid touching blades whenever possible, and always wear gloves to protect hands. 1. Always grip support handle with right hand and throttle handle with left hand. 2. Hold trimmer firmly and squeeze thr...

  • Page 15

    H edge c lipper 15 o perator ' s m anual maintenance intervals skill levels level 1 = easy to do. Common tools may be required. Level 2 = moderate difficulty. Some specialized tools may be required. Echo offers repower tm maintenance kits and parts to make your maintenance job easier. Component/syst...

  • Page 16

    16 air filter level 1. Tools required: 25 or 50 mm (1 or 2 in.) cleaning brush parts required: repower tm air & fuel filter kit. 1. Close choke (cold start position [ ]). This prevents dirt from entering the carburetor throat when the air filter is removed. Brush accumulated dirt from air cleaner ar...

  • Page 17

    H edge c lipper 17 o perator ' s m anual spark plug level 2. Tools required: t-wrench, feeler gauge, soft metal brush parts required: repower tm tune-up kit important use only ngk bpm-8y spark plug (bpmr-8y in canada) other- wise severe engine damage may occur. 1. Remove spark plug and check for fou...

  • Page 18

    18 a b 1. Remove muffler cover (a). 2. Remove starter cover (b) and clean dirt and dust from fins. Important do not use a metal scraper to remove dirt from the cylinder fins. 3. Assemble components in reverse order. Exhaust system spark arrestor screen level 2. Tools required: 4 mm hex wrench, cross...

  • Page 19

    H edge c lipper 19 o perator ' s m anual exhaust port cleaning level 2. Tools required: 4 mm hex wrench, wood or plastic scraper parts required: as needed: heat shield 1. Remove spark plug lead from spark plug, and remove engine cover (2 screws). 2. Place piston at top dead center. Remove muffler (a...

  • Page 20

    20 important if the engine is adjusted for operation above 1,100 feet asl, the carburetor must be re-adjusted when operating the engine below 1,100 feet asl, otherwise severe engine damage may result. Level 2. Tools required: screwdriver, tachometer (echo p/n 99051130017). Parts required: none. Note...

  • Page 21

    H edge c lipper 21 o perator ' s m anual lubrication blades level 1. Tools required: clean rag, 25 or 50 mm (1 or 2 in.) cleaning brush parts required: 20w engine oil (lubrication), 50-50 mixture of kerosene and 20w oil (cleaning). Warning hedge clipper blades are very sharp. Touching them may lead ...

  • Page 22

    22 sharpening blades level 3. Tools required: flat file, screwdriver parts required: none warning hedge clipper blades are very sharp. Touching them may lead to severe personal injury. Avoid touching blades whenever possible, and always wear gloves to protect hands. 1. Disconnect spark plug wire. 2....

  • Page 23

    H edge c lipper 23 o perator ' s m anual blade adjustment level 2. Tools required: (2) 10 mm sockets and extensions parts required: none warning hedge clipper blades are very sharp. Touching them may lead to severe personal injury. Use a socket and extension when adjust- ing blade bolts or blade loc...

  • Page 24

    24 t roubleshooting danger fuel vapors are extremely flammable and may cause fire and/or explosion. Never test for ignition spark by ground- ing spark plug near cylinder plug hole, otherwise serious personal injury may result. T r a h c g n i t o o h s e l b u o r t m e l b o r p e n i g n e m e l b...

  • Page 25

    H edge c lipper 25 o perator ' s m anual s torage warning during operation the muffler or catalytic muffler and surrounding cover become hot. Always keep exhaust area clear of flammable debris during transportation or when storing, otherwise serious personal injury may result. Long term storage (ove...

  • Page 26

    26 s pecifications model ---------------------------------------------------- hc-245 length ------------------------------------------------------ 1,342 mm (52.8 in.) width -------------------------------------------------------- 251 mm (9.88 in.) height ---------------------------------------------...

  • Page 27

    H edge c lipper 27 o perator ' s m anual echo limited warranty statement for product sold in usa and canada beginning 01/01/2010 echo's responsibility echo incorporated’s limited warranty, provides to the original purchaser that this echo product is free from defects in material and workmanship. Und...

  • Page 28

    28 purchased repair parts, short blocks and accessories • 90-day residential, or non-income producing warranty • 30-day commercial, institutional, agricultural, industrial, income producing, or rental application warranty attention two-stroke engine power product owners this echo two-stroke engine p...

  • Page 29

    H edge c lipper 29 o perator ' s m anual echo incorporated emission control warranty statement for echo and shindaiwa brands the environmental protection agency (epa) and the california air resources board (c.A.R.B.) and echo incorporated (echo inc.) are pleased to explain the emission control syste...

  • Page 30

    30 notes.

  • Page 31

    H edge c lipper 31 o perator ' s m anual notes.

  • Page 32

    Echo, incorporated 400 o akwood r oad l ake z urich , il 60047 www.Echo-usa.Com s64911001001/s64911999999 s72412001001/s72412999999 dealer? Call 1-800-432-echo 1-800-432-3246 or www.Echo-usa.Com consumer product support 1-800-673-1558 8:30 - 4:30 mon - fri c.S.T. S ervicing i nformation parts / seri...