1. DL manuals
  2. Echo
  3. Lawn and Garden Equipment
  4. HCAA-2400A
  5. Operator's Manual

Echo HCAA-2400A Operator's Manual

Summary of HCAA-2400A

  • Page 1

    M o d e l hcaa-2400a hcaa-2401a hcaa-2403a hcaa-2404a operator’s manual manuel d’utilisation bedienungsanleitung manuale d’istruzioni warning, see operator’s manual lire soigneusement ce manuel avant toute utilisation achtung: bedienungsanleitung lesen! Attenzione, leggete il manuale d’istruzioni en...

  • Page 2: Table of Contents

    2 table of contents specifications, descriptions and illustrative material in this literature are as accurate as known at the time of publication, but are subject to change without notice. Illustrations may include optional equipment and accessories, and may not include all standard equipment. The o...

  • Page 3: Safety

    H edge c lipper o perator ’ s m anual 3 manual safety symbols & important information throughout this manual and on the product itself, you will find safety alerts and helpful, information messages preceded by symbols or key words. The following is an explanation of those symbols and key words and w...

  • Page 4

    4 danger fuel is very flammable. Use extreme care when mixing, storing or handling, or serious personal injury may result. - use an approved fuel container. - do not smoke near fuel. - do not allow flames or sparks near fuel. - fuel tanks/cans may be under pressure. Always loosen fuel caps slowly al...

  • Page 5

    H edge c lipper o perator ’ s m anual 5 physical condition -- your judgment and physical dexterity may not be good: - if you are tired or sick, - if you are taking medication, - if you have taken alcohol or drugs. Operate unit only if you are physically and mentally well. Eye protection -- eye prote...

  • Page 6

    6 safe operation determine operation area - review the area to be trimmed. Look for hazards that could contribute to unsafe conditions. Do not operate unit if any wires (power, telephone, cable, etc.) are closer than 5 m to any part of the operator or unit. - spectators and fellow workers must be wa...

  • Page 7

    H edge c lipper o perator ’ s m anual 7 vibration and cold -- it is believed that a condition called raynaud’s phenomenon, which affects the fingers of certain individuals may be brought about by exposure to vibration and cold. Exposure to vibration and cold may cause tingling and burning sensations...

  • Page 8: Description

    8 description 1 1. Operator’s manual - read and understand this manual before operation. Keep manual in a safe location for future reference, i.E., operation, maintenance and specifications. 2. Blades - double reciprocating blades mounted to a blade support bar. Double-sided blades are capable of cu...

  • Page 9: Specifications

    H edge c lipper o perator ’ s m anual 9 hcaa-2400a hcaa-2403a hcaa-2401a hcaa-2404a mass unit with specified cutting blade kg 2.2 2.7 cutting device type dual action, double sided length mm 510 pitch mm 35 height mm 21 gear ratio 3.95 reduction external dimensions length mm 810 1015 width mm 110 130...

  • Page 10: Pre-Operation

    10 after refuelling; - wipe any spilled fuel from the unit. - move at least 3 m from refuelling location before starting the engine. After use; - do not store a unit with fuel in its tank. Leaks can occur. Return unused fuel to an approved fuel storage container. Handling fuel fuel fuel requirements...

  • Page 11

    H edge c lipper o perator ’ s m anual 11 s m t w t f s 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 equipment check before operation a complete check of the unit must be performed; - check unit for loose/missing nuts, bolts and screws. Tighten and/or replace as...

  • Page 12

    12 o peration adjusting cutting angle warning never adjust cutting assembly with engine running. Warning hedge clipper blades are sharp. Always wear gloves when adjusting cutting assembly. Warning do not stand hedge clipper on end when adjusting cutting angle, otherwise serious injury may result 1. ...

  • Page 13

    H edge c lipper o perator ’ s m anual 13 hedge trimming 1. Hold trimmer firmly and squeeze throttle trigger to accelerate engine. 2. Tilt trimmer so cutting teeth are angled slightly toward the hedge or shrub and proceed to cut. Warning never remove hands from unit when blades are moving. Warning th...

  • Page 14: Maintenance

    14 1. Brush loose debris from blade and coat both sides of blade with the 50 : 50 cleaning mixture. 2. Allow cleaning mixture to soften the remaining gummy residue then wipe it from the blade. 3. Apply clean oil to the entire length of the blade. Be certain the blade bolts are lubricated. 4. Wipe ex...

  • Page 15

    H edge c lipper o perator ’ s m anual 15 sharpening blades tools required: flat file, small screwdriver. Parts required: gear box gasket, lithium based grease. Note blade sharpening requires removal of blades from the unit. Step by step instruction are included in the service manual that apply to yo...

  • Page 16

    16 declaration “ce” of conformity the undersigned manufacturer: kioritz corporation 7-2 suehirocho 1-chome ohme ; tokyo 198-8711 japan declares that the hereunder specified new unit: portable hedge trimmer brand : echo type : hcaa-2400a,hcaa-2401a hcaa-2403a,hcaa-2404a assembled by: echo, incorporat...

  • Page 17

    H edge c lipper o perator ’ s m anual 17 gb hcaa-2400a serial number s56435001001 and up hcaa-2401a serial number s56535001001 and up hcaa-2403a serial number s56635001001 and up hcaa-2404a serial number s56735001001 and up tokyo, december 1st 2007 authorized representative in europe: company: count...

  • Page 18

    7-2 suehirocho 1-chome, ohme, tokyo 198-8711, japan phone: 81-428-32-6118. Fax: 81-428-32-6145. X753-003 43 1 x753 224-790 2 gb © 2007.