Echo HCAS-2200 Service Data

Summary of HCAS-2200

  • Page 1

    Hcas-2200 15-21d-01 1 2 introduction we are constantly working on technical improvement of our products. For this reason, technical data, equipment and design are subject to change without notice. All specifications and directions in this service data are based on the latest products information ava...

  • Page 2

    Service information 2 hcas-2200 1 service information 1-1 specifications model hcas-2200 dimensions length mm(in) 1695 (66.7) width mm(in) 250 (9.8) height mm(in) 234 (9.3) dry weight kg(lb) 6.4 (14.0) engine type kioritz, air-cooled, two-stroke, single cylinder rotation counterclockwise as viewed f...

  • Page 3

    Service information 3 hcas-2200 1-2 technical data engine idling speed r/min 2700 - 3200 wide open throttle speed r/min 9500 - 11500 clutch engagement speed r/min 3700 - 4300 compression pressure mpa (kgf/cm 2 ) (psi) 0.72 (7.3) (104) ignition system spark plug gap mm (in) 0.6 - 0.7 (0.024 - 0.028) ...

  • Page 4

    Service information 4 hcas-2200 1-3 torque limits descriptions size kgf • cm n• m in• lbf starter system m 4* 45 - 55 4.5 - 5.5 40 - 48 starter case ignition ignition coil m 4* 45 - 55 4.5 - 5.5 40 - 48 system ignition switch m 4 30 - 40 3 - 4 26 - 35 fan cover m 4 30 - 40 3 - 4 26 - 35 spark plug m...

  • Page 5

    Service information 5 hcas-2200 description mm (in) cylinder bore when plating is worn and aluminum can be seen piston outer diameter min. 32.10 (1.264) piston pin bore max. 8.030 (0.3161) piston ring groove max. 1.6 (0.063) piston ring side clearance max. 0.1 (0.004) piston pin outer diameter min. ...

  • Page 6

    Service information 6 hcas-2200 a 5.3 20 20 40 40 60 60 80 80 120 120 140 140 160 160 180 180 20 20 100 100 91 02 0 key part number description used for: 1 897801-33330 tachometer pet-1000 measuring engine speed 2 363018-00310 washer installing crankcase oil seal of starter side 3 895610-79920 l-hex...

  • Page 7

    Service information 7 hcas-2200 2 emission adjustment guide 2-1 general adjusting rules a. Before starting the unit for adjustment, check the following items. 1. The correct spark plug must be clean and properly gapped. 2. The air filter element must be clean and properly installed. 3. The muffler e...

  • Page 8

    Service information 8 hcas-2200 2-3 adjusting carburettor 1. Start engine and warm it up alternating engine speed between wot and idle every 5 seconds for 1 minute. 2. Adjust idle mixture needle and obtain maximum idle speed with 2.5 mm blade small screw driver. 3. Set idle speed to 3,500 r/min by t...