Echo HCR-1500 Service Data

Summary of HCR-1500

  • Page 1

    1 introduction we are constantly working on technical improvement of our products. For this reason, technical data, equipment and design are subject to change without notice. All specifications, illustrations and directions in this service data are based on the latest products information available ...

  • Page 2

    1 service information 1-1 specifications * see note on page 4. Dimensions length mm(in) 1022 (40.2) width mm(in) 237 ( 9.3) height mm(in) 197 ( 7.8) dry weight kg(lb) 5.0 (11.0) engine type kioritz, air-cooled, two-stroke, single cylinder rotation counterclockwise as viewed from the output end displ...

  • Page 3: Service Information

    1-2 technical data engine idling speed rpm 3000 - 3400 maximum speed rpm 10000 - 10500 clutch-in speed rpm 3500 - 4100 compression pressure, standard kgf/cm 2 (psi) 8.5 (121) carburetor zama c1u-k51 type diaphragm horizontal-draught venturi size mm(in) 8.5 (0.335) throttle bore mm(in) 12.7 (0.5) idl...

  • Page 4

    4 service information hcr-1500 1-3 torque limits * apply thread locking sealant. (see below.) † tapping screw. Note: adjusting cutter clearance fasten all cutter bolts to this torque, then back 1/2 turns(180°) counterclockwise. Material location remarks grease gear case rewind spring lithium based g...

  • Page 5: Service Information

    1-5 service limits description mm (in) a cylinder bore when plating is worn and aluminum can be seen b piston outer diameter min. 32.10 (1.264) c piston pin bore max. 8.030 (0.3161) d piston ring groove max. 1.6 (0.063) e piston ring side clearance max. 0.1 (0.004) f piston pin outer diameter min. 7...

  • Page 6

    1-6 special tools a 1 6 10 14 2 7 11 15 3 : a = 4 mm 4 : a = 3 mm 8 12 5 9 13 key part number description used for: 1 tachometer measuring engine speed 2 433019-12330 flange nut removing magneto rotor (flywheel) 3 895610-79920 l-hex wrench (4 mm) removing and installing hex. Socket bolts (m5) 4 8956...

  • Page 7

    2-2 rotating rear handle function 7 hcr-1500 service hint 2 service hint 2-1 rotating rear handle construction throttle trigger throttle trigger throttle lockout throttle spring stopper spring handle stopper handle stopper handle fixture rear handle handle fixture knock button throttle cable latch a...

  • Page 8

    Hcr-1500 8 service hint 2-2 rotating rear handle function a m l d l c f g h k n c e b d l c k c e 2. When the rear handle is rotated 45 or 90 degrees clockwise or counterclockwise, the knock button (g) engages with the dent (h) of rear handle and makes click noise. Throttle trigger (k) is pulled in ...