Echo MS-41BP Use and care manual - page 2

WARNING

WARNING: Handling the brass parts of this product will expose you to lead, a chemical 

known to the State of California to cause birth defects and other reproductive harm. 

Wash hands after handling.

CAUTION

1E

WARNING: Improper use or failure to follow instructions can result in explosive 

failure causing serious eye or other injury. For safe use of this product you must read 

and follow all instructions. Do not leave a pressurized sprayer in the hot sun. Heat can cause 

pressure build-up resulting in possible explosion. Do not store or leave solution in tank after 

use. Always wear goggles, gloves, long sleeve shirt, long pants and full foot protection when 

spraying. Never use any tool to remove pump if there is pressure in the pressure chamber. 

Never pressurize sprayer by any means other than the original pump. Do not attempt to 

modify this sprayer. Replace parts only with manufacturer’s original parts. Never spray 

flammable,  caustic,  acidic,  chlorine,  bleach  or  other  corrosive  solutions  or 

heat, pressure, or gas producing chemicals. Always read and follow chemical 

manufacturer’s instructions before use with this sprayer as some chemicals may 

be hazardous when used with this sprayer.

SK 1158-1

•  PRE-USE CHECK: Before each use check tightness of hose nut to be sure hose is 

  securely attached to the shut-off assembly. Insure hose is securely attached to the 

  tank by tightening hose clamp if necessary. Insure that all nozzle and wand 

  connections are tight. Insure the large pump clamp is tight. Insure the 2 bolts 

  used to attach the pump lever to the pump shaft are tight.

•  Do Not exceed a tank solution temperature of 120º F/ 49º C.

NOTE: The tank and hose may have residual water in it due to quality testing 

performed on the sprayer.