Echo PB-655 Service Data

Summary of PB-655

  • Page 1

    Pb-655, pb-755 21-63g-00 1 introduction we are constantly working on technical improvement of our products. For this reason, technical data, equipment and design are subject to change without notice. All specifications and directions in this service data are based on the latest products i n f o r m ...

  • Page 2

    Service information pb-655 pb-755 2 1 service information 1-1 specifications model pb-655 pb-755 dimensions length* mm(in) 380 (15.0) width* mm(in) 480 (18.9) height* mm(in) 525 (20.7) dry weight** kg(lb) 11.3 (24.89) 11.9 (26.21) engine type kioritz, air-cooled, two-stroke, single cylinder rotation...

  • Page 3

    Service information pb-655 pb-755 3 1-2 technical data model pb-655 pb-755 engine idling speed r/min 2400 - 2800 wide open throttle speed r/min 6800 - 7300 compression pressure mpa (kgf/cm 2 ) (psi) 1.05 (10.7) (152) ignition system spark plug gap mm(in) 0.6 - 0.7 (0.024 - 0.028) minimum secondary v...

  • Page 4

    Service information pb-655 pb-755 4 1-4 special repairing materials material location remarks grease rewind spring starter center post lithium based grease oil seal inner lips thread locking sealant ball bearing loctite #675 or equivalent muffler loctite #242, threebond #1324 or equivalent starter c...

  • Page 5

    Service information pb-655 pb-755 5 description mm (in) a cylinder bore when plating is worn and aluminum can be seen b piston outer diameter min. 47. 95 (1.888) c piston pin bore max. 10. 030 (0.395) d piston ring groove, 1st max. 1. 65 (0.065) 2nd max. 1. 6 (0.063) e piston ring side clearance max...

  • Page 6

    Service information pb-655 pb-755 6 key part number description used for: 1 897801-33330 tachometer pet-1000 measuring engine speed to adjust carburettor 2 91004 module air gap gauge adjusting pole shoe air gaps 3 895610-79920 l-hex wrench (4 mm) socket bolt (m5) 4 895611-79920 l-hex wrench (5 mm) s...

  • Page 7

    Service information pb-655 pb-755 7 1. Remove plugs from idle mixture needle hole (a) and h mixture needle hole (b) using limiter plug tool (c) as follows. (1)put limiter plug tool (c) on limiter plug in mixture needle hole. (2)push and turn limiter plug tool anticlockwise 2 turns into limiter plug ...

  • Page 8

    Service information pb-655 pb-755 8 2-3 adjusting carburettor 1. Start engine and warm it up alternating engine speed between wot and idle every 10 seconds for 1 minute. 2. Adjust idle mixture needle with 2.5 mm blade screwdriver (e) to reach maximum engine speed just before drop off. 3. Set idle sp...