Echo Power Pruner PPF-2100 Service Data

Other manuals for Power Pruner PPF-2100: Operator's Manual
Manual is about: Echo Pole Saw - Power Pruner User Manual

Summary of Power Pruner PPF-2100

  • Page 1

    1 introduction we are constantly wor king on technical improvement of our products. For this reason, technical data, equipment and design are subject to change without notice. All specifications, illustrations and directions in this service data are based on the latest products infor mation availabl...

  • Page 2

    1 service information 1-1 specifications models ppf-2100 dimensions length(collapsed) mm(in) 2365 (93.1) length(fully extended) mm(in) n/a length(with extension)* mm(in) 3288 (129.5) width mm(in) 230 (9.06) height mm(in) 221 (8.70) dry weight** kg(lb) 5.82 (12.8) engine type kioritz, air-cooled, two...

  • Page 3

    3 service information ppf-2100 ppt-2100 ppt-2400 ppfd-2400 models ppt-2100 ppt-2400 ppfd-2400 dimensions length(collapsed) mm(in) 2260 (89.0) 2734 (107.6) 2320 (91.3) length(fully extended) mm(in) 3410 (134.3) 3884 (152.9) n/a length(with extension)* mm(in) 5000 (196.9) 5468 (215.3) 3910 (153.9) wid...

  • Page 4

    1-2 technical data models ppf-2100 ppt-2400 ppt-2100 ppfd-2400 engine idling speed rpm 2500 - 3000 2500 - 3000 engine speed at maximum power rpm 7500 7500 clutch-in speed rpm 3700 - 4100 3700 - 4100 compression pressure mpa(kgf/cm 2) (psi) 0.85 (8.5) (121) 0.75 (7.5) (107) ignition system spark plug...

  • Page 5

    5 service information ppf-2100 ppt-2100 ppt-2400 ppfd-2400 material location remarks grease drive shaft gear case lithium based grease or echo lube tm rewind spring starter center post thread locking sealant starter case ignition coil fan cover carburetor insulators loctite #222, threebond #1342, or...

  • Page 6

    1-5 service limits 0 5 10 1 2 3 4 5 6 7 8 9 10 11 5k193 5k016 5k042 5k194 5k071 5k171 5k228 5k229 5k230 5k231 a b c d e f g h k l 6 ppf-2100 ppt-2100 ppt-2400 ppfd-2400 service information mm (in) description ppf-2100 ppt-2100 ppt-2400 ppfd-2400 a cylinder bore when plating is worn and aluminum can ...

  • Page 7

    1-6 special tools a 1 7 11 15 2 8 12 16 3 4 : a = 4 mm 5 : a = 3 mm 9 13 17 6 10 14 7 service information ppf-2100 ppt-2100 ppt-2400 ppfd-2400 key part number description used for: 1 tachometer measuring engine speed 2 363018-00310 washer installing crankcase oil seal of starter side 3 433019-12330 ...

  • Page 8

    8 ppf-2100 ppt-2100 ppt-2400 ppfd-2400 service procedure (e) (f) (g) (g) (k) (l) (m) (n) (o) (p) (q) (r) (s) (t) (a) (b) (c) (c) (d) (i) (h) (h) (h) (j) (a) nut for stud bolt (b) e-ring (c) washer (d) sprocket (e) bar stud bolt (f) shaft connector (except ppf-2100) (g) retaining ring (h) ball bearin...

  • Page 9

    2-2 checking oil line 1. Disconnect oil line from the auto-oiler and remove oil tank from the gear case. 2. Connect pressure tester #897803-30130 to the oil line (a) using appropriate connector pipe (b) (recommended outer dia. : 4 - 5 mm). 3. Apply pressure approximately 0.01 mpa (0.1 kgf/cm 2 ) (1....

  • Page 10

    10 service procedure ppf-2100 ppt-2100 ppt-2400 ppfd-2400 (a) (b) (c) (a) l o c t it e 6 0 9 2-5 removing worm gear 1. Remove e-ring, washer, sprocket, another washer, then auto-oiler. 2. Screw worm remover #897708-19835 (a) on to the worm. 3. Insert handle (b) in the tool. 4. Screw hex socket bolt ...

  • Page 11

    11 service procedure ppf-2100 ppt-2100 ppt-2400 ppfd-2400 2-8 replacing drive gear and bearing 1. Separate gear case and take out gear sets. 2. Remove retaining ring (a). 3. Set the bearing cage on a vise or equivalent. 4. Push out drive gear (b). Note: removed bearing may never be reused since the ...

  • Page 12

    12 service procedure ppf-2100 ppt-2100 ppt-2400 ppfd-2400 2-10 assembling gear case 1. Clean sealing channels thoroughly on upper and lower case housings. 2. Apply thin bead of black 100% silicon rubber sealant (dow #732, loctite #593 or equivalent) into channels. Note: make sure to apply sealant on...