Operator’s manual power sprayer shr-210 x750-004 14 5 x750604-530 5 847-540-8400 -1564 printed in japan 1204arh 1763 es warning users of this equipment risk injury to themselves and others if the unit is used improperly and/or safety precautions are not followed. Echo provides an operator’s manual a...
Warning the engine exhaust from this product contains chemicals known to the state of california to cause can- cer, birth defects or other reproductive harm. Copyright © 2002 all rights reserved. - 2 -.
- 3 - l/min : fl oz us/min 2-head nozzle 4.2 142 (line type) 4-head nozzle 1.5 50.8 (ring type) 7-head nozzle 2.0 67.6 (line type) variety of nozzle for echo power sprayer shr-210 convenient to use and reliable, the go anywhere shr-210 power sprayer is highly versatile with a large variety of option...
- 4 - important rules for safe operation 1. Handle gasoline with care. It is highly infl amma- ble. - refuel before starting work. - do not smoke while handling fuel. - do not refuel a hot engine. - avoid spilling fuel or oil. Always wipe unit dry before using. - move at least 3 m (10 feet) away fro...
- 5 - nomenclature nozzle chemical liquid tank air cleaner pump throttle lever liquid valve fuel tank spray hose fuel tank cap starter handle ignition switch safety decal: part number 890160- 13210 locate this safety decal on your unit. The complete unit illustration found in the “nomenclature” sec-...
- 6 - assembling shoulder straps • shoulder straps are adjustable to fi t any operator. • adjust straps so that pads rest comfortably on the operator’s shoulders. Spray hose and nozzle • install spray hose, liquid valve, nozzle pipe and nozzle to the machine. Nozzle pipe nozzle liquid valve spray ho...
- 7 - chemical liquid tank strainer chemical (liquid) tank • fill the tank with liquid chemical through the strainer. Do not fi ll without strainer. (dust in the tank may cause clogging of the liquid line or pump.) • the tank contains 19 l (5.0 gal. Us) of liquid. (note) each mark on the side of the...
- 8 - throttle lever idling high speed start hold the machine firmly • pull back choke lever (open position) slowly after engine starts, and keep at idle speed for a while to warm it up. • if temperature is high or engine is warm, keep choke lever half opened or totally opened. Purge bulb fuel retur...
- 9 - spraying • ensure that chemical liquid valve is closed before starting engine. • after engine is warmed up, turn throttle lever to the high speed position (upper position) and open liquid valve. - for safe operation - 1. Secure the chemical tank cap. 2. Check all connections to avoid chemical ...
- 10 - maintenance and care - always keep the machine clean - carburetor case air cleaner cover filter air filter • check before every use. • remove fi lter cover. - remove wing nut. • brush off dust lightly or wash in a non-infl am- mable solvent if necessary. Dry well before reinstalling. 0.6 - 0....
- 11 - breather valve chemical tank breather • clean breather valve and breather hole periodi- cally. • bad sealing of the breather valve may cause a leakage of the chemical. Clogging of the breather hole may cause a “dent” or a breakage of the chemical tank. Breather hole chemical strainer • clean ...
- 12 - emission data high altitude operation this engine has been factory adjusted to maintain satisfactory starting, emission, and durability performance up to 1100 feet above sea level (asl) (96.0 kpa). To maintain proper engine operation and emission compliance above 1100 feet asl the carburetor ...
- 13 - fuel fi lter clogged clean or replace. Fuel pipe clogged clean. Suction insuffi cient make suffi cient. Fuel fi lter clogged clean or replace. Carburetor out of order disassemble and check. C.D.I. Module defective remove and replace. Ignition coil defective remove and replace. Wire connection...
- 14 - improper fuel is used use fuel with correct mixing ratio. Never use gasoline of poor quality. Spark plug defective (burnt) replace. As cooling fi ns clogged, air clean fi ns. Does not pass well excessive deposits in disassemble and remove combustion chamber carbon. Plug damaged or fouled repl...
- 15 - • drain remaining liquid out of the chemical tank. • inspect and adjust every part of the sprayer. - completely clean every part, and repair, if necessary. - apply thin coating of oil on metal parts to pre- vent rust. - remove spraying hose and pipe. Storage after use • drain fuel tank, pull ...
- 16 - warranty statements echo limited warranty statement for product sold in usa and canada beginning 01/01/2010 echo's responsibility echo incorporated’s limited warranty, provides to the original purchaser hat his echo product is free from defects in material and workmanship. Under normal use an...
- 17 - purchased repair parts, short blocks and accessories gd\ uhvlghqwldo ru qrq lqfrph surgxflqj zduudqw\ gd\ frpphufldo lqvwlwxwlrqdo djulfxowxudo lqgxvwuldo lqfrph surgxflqj ru uhqwdo dssolfdwlrq zduudqw\ attention two-stroke engine power product owners this echo two-stroke engine power pro...
- 18 - echo incorporated emission control warranty statement for echo brand the environmental protection agency (epa) and the california air resources board (c.A.R.B.) and echo incorporated (echo inc.) are pleased to explain the emission control system warranty on your 2010 and later equipment/small...
