Echo SRM-2655SI Serivce Data

Summary of SRM-2655SI

  • Page 1

    Srm-2655si 10-25g-01 1 introduction we are constantly working on technical improvement of our products. For this reason, technical data, equipment and design are subject to change without notice. All specifications, illustrations and directions in this service data are based on the latest products i...

  • Page 2

    Service information srm-2655si 2 1 service information 1-1 specifications model srm-2655si(l) srm-2655si(u) dimensions length* mm(in) 1785 (70.3) 1790 (70.5) width mm(in) 360 (14.2) 690 (27.2) height mm(in) 350 (13.8) 460 (18.1) dry weight ** kg(lb) 5.9 (13.0) 6.5 (14.3) engine type kioritz, air-coo...

  • Page 3

    Service information srm-2655si 3 1-2 technical data engine idling speed r/min 2400 - 3000 operating speed r/min 7000 wide open throttle speed* r/min 8500 - 10000 clutch engagement speed r/min 3100 - 3700 compression pressure mpa (kgf/cm 2 ) (psi) 0.98 (9.8) (138) ignition system spark plug gap mm (i...

  • Page 4

    Service information srm-2655si 4 1-3 torque limits descriptions size kgf•cm n•m in•lbf starter pawl carrier m 8 90 - 120 9 - 12 80 - 100 system starter case m 4* 14 - 28 1.4 - 2.8 12 - 24 ignition magneto rotor (flywheel) m 8 160 - 200 16 - 20 140 - 175 system ignition coil m 5 40 - 60 4 - 6 35 - 52...

  • Page 5

    Service information srm-2655si 5 5k223 5k224 5k225 5k016 5k042 5k182 5k222 5k188 0 5 10 1 2 3 4 5 6 7 8 9 10 11 5k189 5k219 5k220 1-5 service limits a b c d e f g h k l m description mm (in) a cylinder bore when plating is worn and aluminium can be seen b piston outer diameter min. 33.91 (1.335) c p...

  • Page 6

    Service information srm-2655si 6 a 1.5 1.65 1.3 0.4 20 20 40 40 60 60 80 80 120 120 140 140 160 160 180 180 20 20 100 100 ec ho key part number description used for: 1 897801-33330 tachometer pet-1000 measuring engine speed 2 895612-79920 l-hex wrench (3 mm) removing and installing hex. Socket bolts...

  • Page 7

    Service information srm-2655si 7 2 emission adjustment guide 2-1 general adjusting rules before starting the unit for adjustment, check the following items. 1. The correct spark plug must be clean and properly gapped. 2. The air filter element must be clean and properly installed. 3. The muffler exh...

  • Page 8

    Service information srm-2655si 8 2-3 adjusting carburettor 1. Start engine and warm it up well for about 3 - 5 minutes with cycle of 50 seconds wot (wide open throttle) and 10 seconds at idling. 2. Adjust idle mixture needle and obtain maximum idle speed with 2.5 mm blade screw driver. 3. Set idle s...