Echoplex EP101 Brochure & Specs - page 2
EP101
ECHOPLEX
®
PREAMP
DUNLOP MANUFACTURING, INC.
P.O. BOX 846 BENICIA, CA 94510 U.S.A.
TEL: 1-707-745-2722 FAX: 1-707-745-2658
CONTROLS
GAIN knob controls amount of
gain added to signal
FOOTSWITCH toggles effect on/
bypass (blue LED indicates on)
POWER
The Echoplex
®
Preamp is powered
by one 9-volt battery (remove
bottom plate to install), a 9-volt
AC adapter such as the Dunlop
ECB003/ECB003E, or a DC Brick
™
power supply
.
DESCRIPTION
• The EP-3’s legendary tone
conditioning mojo in a Phase
90-sized box
• Adds up to +11dB of gain
• Warm, light overdrive at
higher levels
• True Bypass
DIRECTIONS
• Run a cable from your guitar to
the Echoplex Preamp’s INPUT
jack and run another cable from
the Echoplex Preamp’s OUTPUT
jack to your amplifier.
• Start with the GAIN control at
Position 5 (+0dB).
• Turn the effect on by depressing
the footswitch.
• Rotate the GAIN knob clockwise
to increase gain (up to +11dB) or
counterclockwise to decrease it.
• Starting at position 7, the
Echoplex Preamp will produce
light overdrive clipping.
TONE CONDITIONING TIPS
• Start with the Echoplex Preamp
at the end of your effects chain.
In this position, the EP101 will
sweeten up the sound of the
entire chain and also act as a
buffer.
• For a different sound, try placing
the EP101 after your gain pedals
(boost, overdrive, distortion,
fuzz) but before your modulation
pedals (phaser, flanger, chorus,
delay, etc.).
• To use the EP101 as a true
preamp, or as a lead boost,
put it at the beginning of your
effects chain.
SPECIFICATIONS
Input Impedance
730 kΩ
Output Impedance*
55 kΩ
Max Input Level
-5 dBV
Max Output Level
+5.5 dBV
Noise Floor**
-95 dBV
Max Gain
+11 dBV
Bypass
True Hardwire
Current Draw
12 mA
Power Supply
9 volts DC
*Gain at middle position
**A-weighted, Gain at maximum
clockwise position