Electric chainsaw ecs01 instruction manual any questions or problems – please contact the eckman helpline on 0845 555 4440 please read these instructions carefully before use and keep them in a safe place for future reference..
- 1 - contents guarantee……………………………………………………………………………….1 environmental protection……………………………………………………………2 safety instructions………………………………………………………………………2-3-4 technical data and parts identification……………….. ………………….4-5 setting chain bar and chain……………………………………………………… 5 setting the chain saw tension……...
- 2 - environmental protection waste electric products should not be disposed of with household waste. Please recycle where facilities exist. Check with your local authority or retailer for recycling advice. Safety instructions before using the chainsaw, please read the following instructions and fo...
- 3 - safety rules – general and for electric chainsaws 1. Replacement parts. When servicing, use only identical replacement parts. 2. Plugs. Do not modify the plug connected to the power lead in any way. 3. Cleanliness. Keep work area clean. Cluttered areas invite injuries. Do not start cutting unt...
- 4 - the guide bar up and back towards the operator. Pinching the saw chain along the top of the guide bar may push the guide bar rapidly back towards the operator. Either of these reactions may cause you to lose control of the saw that could result in serious injury to user. The following precauti...
- 5 - setting chain and chain bar chain and chain bar assembly for model with sds tool-less tensioning system 1. Place the chainsaw with the motor on a cover to avoid any mess from the oil. 2. Place the chain in the grove of the bar. Pay attention to the correct running direction. As shown by the ru...
- 6 - chain bar. On reassemble if the chainsaw is still not working. Please take it to an authorized service centre. Avoiding kickback be constantly aware of the position of the upper quadrant of the blade tip. This is the part that triggers a kickback when it hits resistance. Never engage the upper...
- 7 - bucking bucking is cutting a fallen log into lengths. Make sure that you have a good footing and stand uphill of the log when cutting on sloping ground. If possible, the log should be supported so that the end to be cut off is not resting on the ground. If the log is supported at both ends and...
- 8 - 2. Keep the left arm as straight as possible. 3. Keep weight on both feet. ● the machine should only be used under reliable support conditions. The machine should be held to the right of the body at a slight distance. ● the chain needs to be moving at full speed before coming into contact with...
- 9 - pic a 1 chain sharpening it is highly recommended that, once the chain loses its ability to cut cleanly and safely, either replace it, have it sharpened by any garden equipment maintenance company, or sharpen yourself. To sharpen the chain refer to below and proceed as follows: disconnect from...
- 10 - 6. Turn the bar periodically to use both the sides so that it wears evenly. 7. It is essential that motor cooling vents are kept free from a build-up of sawdust and this decreases the engines tools cooling capacity and causes overheating equipment, oil pump etc. It is recommended that this is...
