1 1 hand push lawn mower, lawn scarifier & lawn aerator (with optional roller) model eketc6 instruction manual please read and save these instructions for further reference! Any questions or problems?-call the eckman helpline on: 0844 441 3011 or go to www.Eckman.Co.Uk.
2 contents i. Parts list .................................................................................. 3-4 ii. Specification ..................................................................... 4 iii. Assembly instructions ....................................................... 4-8 iv. Safety ...
3 i. Parts list part no. Name quantity (pcs) 1 mower cassette 1 2 aerator cassette 1 3 scarifier cassette 1 4 foam padded top handle 1 5 bar a 2 6 lower handle 1 7 bolt 35mm 6 8 handle connection knob 6 9 collection bag 1 10 bag attachment strap 1 11 roller spacer tubes 2 12 roller 1 13 bolt 25mm 2 ...
4 before assembly firstly unpack and check all parts have been supplied. If you think any parts are missing, first check the packaging again before calling the eckman helpline on 0844 441 3011 ii. Specifications product name: grasshopper(3-in-1 mower/aerator / scarifier , with optional roller) model...
5 step 3 attach handle bottom bars to mower by locating the holes at the end of each bottom barover the lugs on the mower body. The bottom bars are sprung so this works best if you first fit one side then push the opposite bottom bar inwards and into place. Step 4 bag assembly （ the bag and frame ar...
6 step 5 to attach the grass catcher, attach both sides of the support to the metal bar that’s located at thebottom of the mower by the height adjustment levers (see picture below). Clip the strap to the hook at the rear of the catcher, loop the strap over the bottom bar of the handle and push throu...
7 step 2 remove the wheels. Step 3 attach roller. A. Attach roller spacer tubes to the both sides of roller. B. Line up the two holes located on metal bar, long bolt for outer hole, short bolt for inner hole. C. Fit short bolt to inner hole fully,as this is used for fixing the roller adjustment leve...
8 d. The roller assembled is completed and ready for operation now . Iv. Safety guidelines · never allow onlookers to place hands, fingers or feet inside any of the accessories (mower/scarifier/aerator) whilst you are working. ·take extra care and wear non-slip shoes if using this machine when the g...
9 v. Height adjustments 1）wheels height adjustments the height of the machine above the ground can be adjusted by moving the height adjustment levers to the required position. To set the lowest position, one at a time pull the adjustment levers located next to the smaller wheels and move them to the...
10 vi. Mower blade calibration adjustments the blades on the push mower are all calibrated prior to leaving the factory and generally do not require adjustment .However adjustments may be required only if you notice a rough, uneven cut; the mower is difficult to push, or the mower simply does not cu...
11 b).Insert a piece of paper between the cutter bar and the reel blades and carefully turn the reel blades by hand. C).All blades should slice the paper evenly along the entire length of the cutter bar while the reel turns smoothly. D).If the mower has an intermittent cut, adjustment should be made...
12 take off the spring loaded connectors from mower cassette and fit them to aerator cassette or scarifier cassette, then squeeze the connectors inwards and fit to the slots. Ensure that both spring-loaded connectors are fully locked in place before attempting to use the machine. (all accessory cass...
13 intended, or if the product has been modified in any way. Proof of purchase will be required. Your statutory rights remain unaffected. Exploded view & parts list.
14.
15.
