1. DL manuals
  2. Eclipse
  3. Speakers
  4. 508DMK3
  5. Owner's Manual

Eclipse 508DMK3 Owner's Manual

Summary of 508DMK3

  • Page 1

    German french it alian sp anish english german french it alian sp anish english parts list parts list check that all of the following items are present ❶ bracket x1 ❷ column x1 ❸ base plate x1 ❹ pan head screw x4 owner's manual contents contents parts list 7 checklist before use 8 safety guidelines ...

  • Page 2: English

    − 8 − english german french it alian sp anish checklist before use checklist before use safety guidelines safety guidelines the following warning and caution signs are used throughout this owner's manual as well as on the product. These signs alert the installer and users of important safety informa...

  • Page 3: German

    − 9 − german french it alian sp anish english 2 spread a soft cloth over the floor in order to prevent damaging the surface of the speaker. 4 remove the speaker angle adjustment nut from the speaker arm. 3 place the speaker on its side. 1 remove the hexagonal head bolt from the speaker arm. Rear vie...

  • Page 4: English

    − 10 − english german french it alian sp anish 6 lift up the speaker to remove it from the speaker arm. Speaker speaker arm 5 stand the speaker upright. Hold the speaker carefully while carrying out adjustment. Caution ･ the speaker is heavy, so hold it firmly while removing it from the speaker arm....

  • Page 5: German

    − 11 − german french it alian sp anish english ❶ bracket ❷ column ❸ base plate ❹ pan head screw x2 1 assemble the base plate and the column using the pan head screws. 2 assemble the bracket and the column using the pan head screws. 3 insert the locking pin of the speaker into the hole in the bracket...

  • Page 6: English

    − 12 − english german french it alian sp anish - connecting the speaker cable - ⊖ ⊕ 1 insert the bare ends of the speaker cable into the holes in the speaker input terminals and secure them in place. 1 loosen the speaker angle adjustment nut. 2 adjust the speaker to the desired angle. 3 tighten the ...