Eclipse 902-482 Instruction Manual - page 5
MAINTENANCE AND SERVICING
Damaged equipment may cause serious personal injury. Do not use damaged
equipment. If abnormal noise or vibration occurs, have the problem corrected before
further using.
1.
Before each use, inspect the general condition of the tool. Check for loose screws,
misalignment or binding of moving parts, cracked or broken parts, or any other
condition that may affect its safe operation.
2.
After using, clean external surfaces of the tool with clean, moist, smear the rust
preventing oil on the metal surface of the tool and the dies to avoid rusty. Store the
tool in the dry environment.
3.
Service to the tool should only be done by a qualified Service Technician.
4.
After a long time, the sealing kits will be damaged, if there is leakage please contact
the manufacturer and/or the distributor to have the sealing kits changed.
1. Description of the components.
Code
Name
Function
1
Ram
Output high pressure to active the piston
2
Turn screw
To release the pressure
3
Active handle
For operating
4
Fixed handle
For storing oil and protect rubber bladder
5
Punch &die
For punching
6
Spacer
To protect the ram and assist tool for punching
7
Draw Stud
For connecting cylinder with punch & die
Capacity and Draw Stud Selection Guide
Draw Studs and
Accessories
Standard Round Knockout Punches (Type D)
.89”
1.11”
1.36”
1.71”
1.96”
2.43”
7/16”Draw Stud
+Spacer
▲
3/4”Draw Stud
+Spacer
▲
▲
▲
3/4”Draw Stud
▲
▲