Eclipse DCU105 Installation Manual

Other manuals for DCU105: Brochure, Brochure
Manual is about: HDD Series DVD Series

Summary of DCU105

  • Page 1

    Be sure to read this installation manual thoroughly prior to installation and making connections. If installation methods or non-standard parts not specified in this installation manual are used, accidents or injury may result. Professional installation is recommended, contact the place of purchase ...

  • Page 2

    - 2 - components components check that all of the following components are present check that all of the following components are present decoder unit x 1 1 interconnecting cable (power and speaker connector) (16p) x 1 2 interconnecting cable (20p) x 1 4 hex-head bolt (red:m5x8) x 4 7 self-adhesive ...

  • Page 3: Tip

    - 3 - warnings and caution signs, illustrated bellow, are posted throughout this manual as well as on the dcu105. They show safe and correct ways to handle the product to prevent personal injury to you and others and avoid damage to property. When reading through the manual, take the time to read th...

  • Page 4

    - 4 - • • play the audio at a moderate volume level that permits you to hear sounds from outside the vehicle. Driving with the inability to not hear outside sounds may result in an accident. • • this product must be operated only as on-board equipment, or it may cause electrical shock or injury. • •...

  • Page 5: Tip

    - 5 - names and functions of ter names and functions of ter minals minals • • never cut the insulation on the power cable or use it to power any other equipment. If the rated current capacity of the power cable is exceeded, fire and electric shocks may result. • • the cables should be secured with t...

  • Page 6

    B+ (yellow) connect where the power is constantly available, regardless of the ignition key's position. Ground (black) connect where good body grounding is available. Dvd mute wire (pink) connect to h/a mute or dvd mute on the main unit. Navi mute wire (brown) connect to navi mute on the navigation ...

  • Page 7

    Center speaker line-out terminal if using a center speaker (sold separately ), connect it to the rca input connector of an external amplifier. Woofer speaker line-out terminal if using a woofer speaker (sold separately ), connect it here. Vtr input terminals (ch1) vtr input terminals (ch2) vtr outpu...

  • Page 8

    - 8 - speak speak er connection e er connection e xamples xamples l r l r mid low mid hi front sw rear center l r l r mid low mid hi front sw rear center l r l r mid low mid hi front sw rear center to center speaker (with amplifier) decoder unit 1 interconnecting cable 2 (power and speaker connector...

  • Page 9

    - 9 - installing the decoder unit installing the decoder unit install the side brackets to the sides of the decoder unit with the supplied screws. 1 attach the self-adhesive pads to the base of the side brackets. 2 life up the carpet underneath the vehicle seat and find a suitable mounting location....

  • Page 10: Tip

    - 10 - when measur when measur ing frequency response char ing frequency response char acter acter istics or carr istics or carr ying out ying out automatic time alignment inside the v automatic time alignment inside the v ehicle ehicle connect the accessory measuring microphone to the decoder unit....

  • Page 11

    - 11 -.

  • Page 12

    - 12 - 090003-28580700 0507de (cn) “eclipse” is a registered trademark of fujitsu ten limited in 48 countries including the u.S. And japan..