Eclipse EC-P50 User Manual - page 30
30 P0016-LU-03.01
User Setup
This section covers programming of the system users. The EC-P50 has a total of 51 users:
f User 00 is the “Engineer” which cannot be selected or changed by the master user.
f User 01 is the “Master” user which has a default code of 5678.
f Users 02 to 50 can be programmed to any user type and default to “Not in Use”.
When setting up a new user for the system the user must be assigned an access code, user
type, areas and optionally a time lock and name.
User Access Code
Each user must be assigned an access code in order to operate the system; access codes
may be 4, 5 or 6 digits in length.
To program a User Access Code, please proceed as follows:
User 02 Code:
ÿ
User 02 Code:
020202ÿ
Enter option number:
: Where ?? is user 01 to 50
81??
Then press
to edit.
e.g. Enter 8102* for User 02.
*
Ensure that User Program Mode is selected.
User Menu:--
Option:----
Enter new access code,
e.g, “020202”.
Press
to accept and return to step
.
Press
to cancel and return to step
.
Press
to accept and move to next option.
*
R
#
Ì
Ë
Ur
81 02 =
81 02 =0 20
...
If the remote keypad generates an error tone after pressing the
*
or
#
key at
step 3, then the access code cannot be used. Simply repeat the procedure from
step 2 but use an alternative access code at step 3.