Eclipse TD712ZMK2 Installation Manual - Installation
−−
JAPANESE
ENGLISH
GERMAN
FRENCH
ITALIAN
SPANISH
Installation
Installation
- Installing the speaker -
Place the stand in the desired location.
1
Remove the guide screw from the stand.
2
The assembly of this unit must be done on a flat, hard
surface. If the stand is placed in such a way that it
obstructs free passage, injury may result.
Caution
Speaker
stand
Install the guide screw to the speaker as shown in the
illustration.
3
If placing the speaker on the floor, lay some protective
material on the floor to prevent any damage to the speaker
and the floor.
Caution
As shown in the diagram, mount the speaker on the
stand, constantly checking the alignment.
4
・ When placing the speaker, be careful not to touch the
cone paper. Damage to the speaker may result.
・ When placing the speaker on the stand, do not tilt the
speaker by mistake, otherwise the base of the speaker
may become damaged.
・ When placing the speaker on the stand, do not tilt it while
working, otherwise the guide pin may fall down and injury
or damage to the floor may occur.
Caution
Speaker
stand
Speaker
Insert the guide pin into the stand, and align the speaker
with the three pins.
Tip
Guide
pin
Speaker
Tighten the guide screw to secure the speaker to the
stand.
5
Speaker
Guide screw
Tighten
Guide screw
Guide screw
Pin
Groove