ECM ANY SPOT User Manual - System Setup

System Setup

System Setup

5

ECMR Receiver Setup:

Channel Selection

Press channel Selector button to select desired Channel. When 

switching Channels, wait for the Channel number display to stop

blinking before using the ASC function. For best results when 

operating multiple systems, set every channel to achieve the 

maximum distance between channels.

Receiver Volume Control:

Turn Left for Output Level decrease, turn Right for Output Level 

increase.

Mute Level Threshold Adjustment:

The Mute Level is factory set and normally needs no adjustment. 

However, you may turn clockwise if interference is present.

Automatic Transmitter Setup (ASC):

Remove the access cover on the Handheld Transmitter. Point the 

IR Window of the Handheld towards the IR Window on the 

Receiver and press the ASC button.

Start by pressing the ASC button on the MBP52 transmitter belt 

pack. The LED on top will flash green for 15 seconds.

While it’s flashing, Point the IR window of the MBP52 belt pack 

towards the IR window on the Receiver, and press the ASC 

button on the ECMR receiver. If you have successfully synced 

them, The orange RF LED on the ECMR receiver will turn on 

indicating a signal from the transmitter.

Note: when establishing infrared connection between the receiver and 

the transmitter, the distance between them should not exceed O.5m. 

When more than one system are used, only IR window of one 

transmitter should be pointed to the receiver for each infrared 

connection.