ECM Barista User Manual - page 18
ENGLISH
Instruction manual BARISTA
17
13 CE Conformity
Conformity
The product complies with the following EU Directives:
Machine:
2006/42/EC
Low Voltage:
2006/95/EC
EMC:
2004/108/EC
PED:
97/23/EC
EN-Directives:
EN 292-1, EN 292-2, EN 60335-1, EN 60335-2-15 or EN 60335-2-75, EN 55014, EN 61000-3,
EN 61000-4, ENV 50141, EN 55104
14 Disposal
WEEE Reg. No.: DE69510123
This product complies with EU Directive 2002/96/EC and is registered according to WEEE (Waste Electrical and
Electronic Equipment).
15 Troubleshooting
Problem
Possible cause
Troubleshooting
The grind is not fine enough
Use a finer grind.
Tamp the ground coffee more firmly.
The coffee is too old.
Use fresh coffee.
There is too much chlorine in the
water.
Use a chlorine filter.
The amount of ground coffee is not
enough.
Take the right coffee amount:
Use approx. 7-9 g (1/4 ounce) of
coffee for each cup.
Little or no crema on top of the
coffee
The shower screen is dirty.
Clean the brew group.
The grind is too fine.
Increase the grind setting.
Tamp the ground coffee only
slightly.
Sparse coffee dispensing, only drop
by drop
There is too much ground coffee.
Use approx. 7-9 g (1/4 ounce) of
coffee for every cup.
The grind is not fine enough.
Reduce the grind setting.
The coffee is old.
Use fresh coffee.
The amount of ground coffee is not
enough.
Use approx. 7-9 g (1/4 ounce) of
coffee for each cup.
Weak “body”
The shower screen is dirty.
Clean the shower screen.
The coffee beans are improper
Use another coffee bean.
Foam instead of crema
The setting of the coffee grinder is
not suited for the coffee mixture in
use
Adjust the coffee grinder (When
changing the coffee beans, changing
the grind may also be necessary.)
The orange control lamp is switched
off: there is not enough water in the
water tank.
Refill water.
Water was refilled, the orange
control lamp is switched off.
Switch on/off the machine.
The machine is switched on, but the
machine does not work.
The water tank is not fixed properly.
Fix the water tank properly.