Eco Air ECO DD322FW CLASSIC User Manual - page 12
11
Lift by the handle
Pull bucket out
Remove the cover
Pour the water contents
Refit the cover
Restore the bucket
1. When the bucket is full, the FULL LED lights up and the unit stops.
2. Do not move the unit or remove the bucket, if the machine is still operating, as
water may leak, damage the unit or cause an electric shock.
3. To remove the bucket, pull it out by
gripping the bottom of the bucket,
and lift carefully.
4. Remove the cover of bucket first,
then pour the water away, clean the
bucket and restore the cover and the
bucket to the correct position.
TO EMPTY THE BUCKET
PERMANENT DRAIN OPTION
NOTE:
Clean the bucket with clean water if needed. Do not use detergent, solvent,
abrasive or hot water to avoid damage to the appliance.
Do not remove or damage the float in the bucket, the unit will not work correctly.
The bucket cover must be well fitted in position.
The "FULL" LED lights if the bucket is not well in place.
1
2
3
4
5
6
A hose with an inner diameter of 12mm can
be connected for continuous drainage.
1. Remove the bucket.
2. There is a through hole at the lower left
corner on the back of the appliance.
3. Pass the hose through the hole.
4. Remove the plug from the drain hole at
the back of the bucket. Keep it safely for
future use.
5. Push and connect the hose firmly to the
drain hole of the bucket.
6. Restore the bucket in the correct position.
A
B
C
D
E
F