Eco Airflow 1500 Maintenance Manual
MAINTENANCE GUIDE
MAINTENANCE
We recommend the filter be checked and cleaned once
per month.
Before servicing the filter, first disconnect the power
supply, then remove the filter from the designated slot.
Remove any build up on the outside screen with either a
soft cloth or the soft brush attachment of a vacuum.
Once the screen has been cleaned, hold the filter up to a
light. If the black strings can be seen, the filter pads DO
NOT need to be replaced. If the black strings cannot be
seen, replace the pads. The filter pads typically need
replacing every three months.
If the filter pads need replacing, follow the steps
illustrated on the reverse side of this document.
MANUFACTURED BY
Model 1500
1“ ELECTRONIC AIR CLEANER
OPERATION
When the Model 1500 is operating, the power supply
light will be ON. If the light does not come on when
power is supplied to the air cleaner, refer to the trouble-
shooting section below. The Model 1500 uses little
power (less than 2 watts) and is on continuously. The
furnace fan should operate continuously for increased air
filtration in your home.
TROUBLESHOOTING
If the air cleaner does not seem to be functioning, check
the following:
1. Check that the power supply light is “ON”. If
the light is “OFF”, check the power supply and
wiring connections.
2. If the power is not being supplied to the power
head, it may need to be replaced. Contact your
dealer / contractor or call customer service at
ECOairflow.
www.ecoairflow.com
tel: 1:877-347-3569 . fax:1-866-367-8826
1885 Clements Road, Unit 210, Pickering, ON L1W 3V4
WAYS TO ORDER
2
2
1
1. Call your dealer/contractor
Order direct from ECOairflow
. tel: 1:877-347-3569
. fax:1-866-367-8826
. online: www.ecoairflow.com
. email: customerservice@ecoairflow.com
When ordering, please let us know the filter model number and filter size.
NOTE: