ECO-heater C400C Use And Care Instructions - page 2
SELECTING A PROPER LOCATION
* The enclosed foam packing will serve as a drilling template.
1. Mark the positions of the four holes to be drilled on
the wall. (Install heater 6” to 18” above the floor to get
best performance.)
2. Drill holes with the drill bit from the accessories pack.
3. Insert the plastic mounting posts into the holes.
4. If you are installing a heat reflector, then follow
these steps:
a. Place the reflector in the middle (equidistant) of the 4
mounting post, and mark the corners’ position on the wall.
b. Start at one corner, peeling off the protective paper from
the back, and press the corner in place.
c. PLEASE NOTE THAT THE ADHESIVE IS VERY STRONG AND
These room features can affect the efficiency of your ECO-heater:
IT WILL BE VERY DIFFICULT TO REPOSITION THE HEAT
REFLECTOR ONCE YOU BEGIN APPLYING IT TO THE WALL.
d. Continue pulling the paper off the back as you press
the reflector onto the wall, until the paper is completely
removed.
5. Install the panel heater onto the four mounting
posts matching the four holes in the heater.
6. Screw the 4 fasten bolts into the mounting posts.
7. Put the caps onto the fasten bolts. Some glue
can be used to stick the caps onto the bolts.
8. Make sure the distance between the bottom of
the heater and the floor is no less than 4” when the
heater is installed.
UNPACKING AND WALL MOUNTING INSTRUCTIONS
A floor plan that has open access
to other rooms.
Numerous windows.
Large rooms may need multiple
heaters.
Inadequate insulation, however, the
use of an optional reflective thermal
shield will help overcome this issue.
Heater placed near a stairway to an
upper floor.
Exterior doorway.
1.
4.
2.
3.
5.
6.