1. DL manuals
  2. Eco-ideal
  3. Stove
  4. eco 2
  5. Installation And Operating Instructions Manual

Eco-ideal eco 2 Installation And Operating Instructions Manual

Manual is about: clean burn

Summary of eco 2

  • Page 1

    Jineco02 revg 11/06/12 eco 2 2 2 2 clean burn stove installation and operating instructions.

  • Page 2

    Jineco02 revg 11/06/12 eco 2 technical specification appliance mass 87 kg total efficiency 76.0 % nominal heat output 4.5 kw mean co emission (@13% o 2 ) 0.20 % mean flue gas temperature 272 °c flue gas mass flow 4.5 g/s this appliance is not for use in shared flue this appliance is suitable for int...

  • Page 3

    Jineco02 revg 11/06/12 general guidance it is important that your stove is correctly installed as hunter stoves cannot accept responsibility for any fault arising through incorrect use or installation. These instructions cover the basic principles to ensure satisfactory installation of the stove, al...

  • Page 4

    Jineco02 revg 11/06/12 fireguards always use a fireguard in the presence of children, the elderly or the infirm. The fireguard should be manufactured in accordance with bs8423 – fireguards for use with solid fuel appliances. Do not over-fire it is possible to fire the stove beyond its design capacit...

  • Page 5

    Jineco02 revg 11/06/12 assembly instructions f lue c ollar and b lanking wind the eight m6 studs supplied into the fixing holes in the flue collar and blanking plate until finger tight. Place a flue outlet gasket in position on the top plate of the stove and lower the flue collar blanking plate (as ...

  • Page 6

    Jineco02 revg 11/06/12 slide the base of the side brick towards the centre of the stove and remove. Rear brick pull the top edge of the rear brick forward and lift the brick out of the stove. Baffle / throat plate lift the baffle and slide to the left. When the right side of the baffle clears the ba...

  • Page 7

    Jineco02 revg 11/06/12 installation instructions chimney the chimney height and the position of the chimney terminal should conform to building regulations. Check that the chimney is in good condition, dry, free from cracks and obstructions. The diameter of the flue should not be less than 127mm and...

  • Page 8

    Jineco02 revg 11/06/12 minimum draught – 1.2mm water gauge maximum draught – 2.5mm water gauge air supply the room or space containing this appliance should have purpose provided ventilation (where necessary) in accordance with building regulations. Due consideration should be given to air requireme...

  • Page 9

    Jineco02 revg 11/06/12 commissioning & handover upon completion of the installation, allow a suitable period of time for any fire cement and mortar to dry out. A small fire may then be lit and checked to ensure the smoke and fumes are taken from the stove up the chimney and emitted safely to atmosph...

  • Page 10

    Jineco02 revg 11/06/12 operating instructions this appliance is not suitable for use in a shared flue operation with the door open can cause excess smoke. This appliance must not be operated with the door open aerosol sprays do not use an aerosol spray on or near the stove when it is alight. Air con...

  • Page 11

    Jineco02 revg 11/06/12 to burn wood, push the operating tool up and away from you. When left in this position, air is restricted through the bed of the fire providing a solid base to build up a bed of ash. Surplus ash can be removed either by gentle riddling or with a shovel. It might prove benefici...

  • Page 12

    Jineco02 revg 11/06/12 reduced combustion in order to shut down the stove, close the primary control, then close the secondary air slider by moving the handle all the way to the left. If the controls are left in this position, the fire will be starved of air and will die down. If you want to revive ...

  • Page 13

    Jineco02 revg 11/06/12 no liquid fuels should be burnt on this appliance. Should any difficulties arise over fuel quality or suitability, consult your local approved coal merchant or: hetas ltd – telephone 01242 673257 – www.Hetas.Co.Uk solid fuel association – telephone 0800 600 000 – www.Solidfuel...

  • Page 14

    Jineco02 revg 11/06/12 chimney and flueways it is important that the chimney, flueways and any connecting flue pipe are swept regularly. This means at least once a year for smokeless fuels and at least twice a year for wood and other fuels. The baffle will need to be removed from its supports in ord...

  • Page 15

    Jineco02 revg 11/06/12 spares information d oor spares single door (hec05/001) glass clip screw (fsjm05008ss) door slider (ch05/009) glass gasket (eco02/015) door handle assembly (eco02/arrt/006) glass clip (hhr08/046) slider knob (hce06/059) door cover (hec05/002) door glass (eco02/010) rope sealin...

  • Page 16

    Jineco02 revg 11/06/12 b ody a ssembly s pares cam bar (hh04/015) ash pan (eco02/016) operating tool (hfr07/040) riddling bar (lower) (cns04/012) riddling bar (upper) (cns04/013) riddling support (hh04/022) tertiary air bar (hh04/105) baffle (hh04/078) catch bar (eco02/014) side brick (hh04/116) rea...