Eco OLK-P-01 User Manual - page 6
www.nbwowtech.com
6
System Set Up
1.
Turn on the water valve/faucet. Check the connections to ensure that there is no leakage or
dripping. Tighten the hose connections, if necessary, but DO NOT over tight.
2.
Connect power adapter, and then start your washer. Once the water begins to flow, the blue light
of the ECO Mini Purifier should begin to glow.
Indicators
There are two states of the LCD control panel screen.
S
Blue Light: work normally.
S
Red Light: work abnormally or break down.
If the unit works abnormally, please contact our Customer Service.
Alarm of Leakage
ECO Mini Purifier is equipped with a switch and an alarm against leakage. If the leakage happens,
the water will accumulate on the bottom panel inside the unit. The sensor will set off an audible
alarm and will automatically turn the unit off. This alarm will continue to buzz until the leak is
stopped and/or the unit is unplugged. If this alarm should occur, you should unplug the unit, turn off
the cold water valve and call our Customer Service team for support.
Replacement of Silver Ion Probe
Under normal usage, the Silver Ion Probe installed in your ECO Mini Purifier has a life expectancy
of approximately one and
a
half years. The
on the control panel will turn RED when the Silver
Ion Probe requires replacement. Please contact our Customer Service team to order a new Silver Ion
Probe and replace it as the following step: