Eco-Smart ECO 36 Installation Instructions Manual

Manual is about: Electric Tankless Water Heater

Summary of ECO 36

  • Page 1

    Page 1 of 11 installation instructions & home owners manual eco 36 important safety information as when installing or using any high voltage electrical appliance, basic safety precautions should always be followed. Under no circumstances should attempt to clean, install, inspect, repair, disassemble...

  • Page 2

    Page 2 of 11 about your tankless water heater congratulations on the purchase of your electric tankless water heater! You have purchased the most technologically-advanced tankless water heater on the market today. Your new electric tankless water heater features advanced water flow rate and temperat...

  • Page 3

    Page 3 of 11 (2) selecting a location to install this product is designed to be installed indoors only. You may be able to install your unit in an outdoor location as long as it is mounted in a suitable enclosure that protects it from rain, splashed water, direct sunlight, debris, and insects. This ...

  • Page 4

    Page 4 of 11 (3) mounting your water heater your tankless water heater should be secured to the mounting surface with 4 screws (minimum 1 inch long) using the built-in mounting brackets on each side of the heater. Make sure that the mounting surface is solid and secure, and ensure that the unit is l...

  • Page 5

    Page 5 of 11 (4) plumbing installation please read these instructions thoroughly and completely before installation and before use. Failure to do so could cause property damage or serious personal injury or death, and void your warranty. Please follow all plumbing instructions carefully. We recommen...

  • Page 6

    Page 6 of 11 step 1 bring the hot water and cold water lines to the heater. We recommend that a manual shut-off valve (ball valve) be installed on the inlet and outlet of the water heater so there is a convenient shut-off point available in the event that future maintenance or servicing is required....

  • Page 7

    Page 7 of 11 installation: step 1 model eco 36 requires 4 sets of wires and ground (see wiring diagram) step 2 take each wire pair and connect them to one breaker (see wiring diagram).Make sure that each breaker has one wire pair-black wire connected to it and one red wire. Caution: ensure that you ...

  • Page 8

    Page 8 of 11 number of breakers needed based on model being installed model eco 36 quantity 4 min. Amp rating 40 type double pole step 1 using a suitable wire gauge that meets all applicable electrical codes for the size of the breakers used, run the correct sets of wire from the home’s main breaker...

  • Page 9

    Page 9 of 11 when you use hot water in your home with a conventional water heater, you need to mix a considerable volume of cold water to cool the hot water down to a safe, comfortable level for showering and bathing, etc. You need to do this with a traditional tank-type water heater because they ar...

  • Page 10

    Page 10 of 11 (7) maintenance your new electric tankless water heater requires no maintenance performance of your water heater and to reduce the risk of a water leak, we do recommend the following maintenance: you should inspect the connections on the inlet and outlet of the water heater at least on...

  • Page 11

    Page 11 of 11 the following table represents some of the most common technical support questions we receive. Before calling us, please read thoroughly to see if your question or problem is addressed. Problem possible cause solution water heater is not heating at all (water is flowing but the unit is...