ECO Spot LED B90E User Manual
ECO Spot LED B90E/B150E/B300E User Manual
Copyright © 2015 Globus New Media LLC
Page 1
Thank you for choosing an ECO Spot™ Gobo projector.
Please read this manual before installing or operating this fixture,
follow the safety precautions listed below and observe all warnings.
WARNING! - To prevent damage to the LED, always
connect the driver to the projector FIRST before
powering up the driver.
Package Contents
Projector with Projection Lens
External LED Driver
Test Gobo mounted
Thread ring with silicone seal for the projection lens
Safety Information
Electrical Safety
•
Disconnect the fixture from AC power before handling it.
•
Follow all local building and electrical codes and apply both, overload and
ground-fault protection.
•
Do not use the fixture if the power cable or power plug is in any way damaged,
defective or wet, or if they show signs of overheating.
•
The fixtures have power plugs for testing and for indoor use but exterior
installations usually require hard-wired connections. Follow all related codes.
ECO Spot™ LED B90E/B150E/B300E
Exterior User Manual
•
Place your fixture at a suitable place with good air flow.
•
Keep flammable materials away from the fixture.
•
Minimum distance to flammable material = 1 ft (0.3m).
•
Provide a minimum clearance of 4 in (10cm) around air vents.
•
Do not look directly into the lamp; it can result in eye damage.
•
Always unplug the unit from the power mains before any service is done.
•
Light fixtures should be installed and maintained only by qualified personnel with
experience in lighting equipment and general electrical experience.