Ecoair DD122 CLASSIC MK5 User Manual - Empty Water Tank
© 2014 EcoAir 6 All rights reserved
Eng
lish
EMPTY WATER TANK
The Water Full Indicator lights up when the water tank is full and the unit stops operating.
Do not move the unit or remove the water tank when the dehumidifier is running, as water
may leak; causing damages to the dehumidifier or an electric shock.
Before removing the water tank leave the dehumidifier to stand for approximately 10 minutes
to ensure all water collected drips into the water tank.
To remove the water tank, pull it out gently by gripping the bottom of the water tank and lift
carefully by the handle.
Remove the cover of the water tank, then pour the water away. Clean the water tank, restore
the cover and handle.
Insert the water tank back to the correct position.
NOTE :
Clean the water tank with clean water if needed. Do not use detergent, solvent, abrasive
or hot water to avoid damaging the dehumidifier.
Do not remove or damage the float in the water tank or the dehumidifier will not operate
properly.
The Water Full light indicator illuminates if the water tank is not correctly in position.
Do not tilt the dehumidifier when removing the water tank.
You may use a hose with an inner diameter of 12mm for continuous drainage:
Use a screwdriver to remove the knockout at the back. Attach the hose to the connector
through the hole at the back of the dehumidifier.
The hose must lead to an appropriate drain at a downward slope with no sharp bends.
NOTE:
Ensure the water tank is well fitted in position before inserting the hose.
Before removing the water tank, ensure that the hose is disconnected.
CONTINUOUS DRAINAGE
Pull water tank out
Lift by the handle
Remove the cover
Pour the water away
Restore the cover and
the handle
Insert the water tank
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
STEP 1
Knockout
STEP 2
Hose
STEP 3
Hose