1. DL manuals
  2. Ecoair
  3. Air Conditioner
  4. ECO1250SD
  5. Installation And Operation Manual

Ecoair ECO1250SD Installation And Operation Manual

Summary of ECO1250SD

  • Page 1

    In s ta ll a ti o n a n d o p e ra ti o n m a n u a l room air conditioners z series inverter range split type dc inverter register your air conditioner model information can be found on the ce label. Please register your product online at www.Ecoair.Org. For your future convenience, record the mode...

  • Page 2: What’S In The Box

    What’s in the box 1 x z series indoor unit 1 x z series outdoor unit 1 x remote control 1 x drain hose 1 x user manual 1 x hole cover plate 1 x drain joint 4 x wall plugs and screws. 1 set of copper pipes wee/ec2601ur this appliance can be used by minors from 8 years and above and persons with reduc...

  • Page 3: Content

    Content operation and maintenance bs plug wiring ........................................................................................................ Safety precautions .................................................................................................. Notices for use................

  • Page 4

    Bs plug wiring wiring instructions: should it be necessary to change the plug please note the wires in the mains lead are coloured in accordance with the following code: blue - neutral brown – live green and yellow - earth as the colours of the wires in the mains lead of this appliance may not corre...

  • Page 5

    Warning please read the following notices before operation ȝ cut off power if there's abnormal pheno- if this abnormal status is kept ȝ ȝ ȝ safety precautions it may on,air conditioner may be damaged or even cause electric shock or fire. Menon(like smell of burning), please cut off the power imm- ed...

  • Page 6

    ȝ ȝ ȝ ȝ ȝ be sure to pull out the power ȝ ȝ ȝ ȝ earth: the ground be connected! If not, please ask the qualified person- nel to install. Furthermore, don't conn- ect each wire to the gas pipe, water pipe, drainage pipe or any other impr- oper places. Plug when not using the air co- nditioner for a l...

  • Page 7

    ȝ safety precautions do not cut off or damage the power cords or control cords. If they are damaged, please contact d qualified service hohfwulfldqru dlufrqglwlrqlqjhqjlqhhu to change the airflow direction, adjust the vertical air flow direction by using the remote controller or adjust horizontal ai...

  • Page 8

    Notices for use working principle and special functions for cooling principle: anti-freezing function: working principle and special functions for heating principle: defrosting: air conditioner absorbs heat in the room and discharges the heat through the outdoor that indoor ambient temperature decre...

  • Page 9

    6 notices for use anti-cool wind function: in "heat" mode, under the following three kinds of state, if indoor heat exchanger doesn't arrive at certain temp, indoor fan will not act, in order to prevent cool wind blowing(within 2 mins): 1. Heating starts. 2.After auto defrost finished. 3.Heating und...

  • Page 10

    ņ Ņ ł ň ʼn Ŋ ń Ň Ń Ł power cord remote controller front panel filter horizontal louver wall pipe binding tape connection wires drain hose drain connecter 21 2)) / 02'( )$1 6:,1* ,)((/ 6/((3 7(03 7,0(521 &/2&. 5 ( 0 , ) ) 2 7 785%2 /,*+7 ;)$1 f c h o ur onoff name of parts Ņ ň Ń ʼn Ŋ Ł ł indoor unit ai...

  • Page 11

    21 2)) / 02'( )$1 6:,1* ,)((/ 6/((3 7(03 7,0(521 &/2&. 7 2)) ,0(5 785%2 /,*+7 ;)$1 f c ： h o u r on of f press it to start or stop operation. On/off mode + - press it to select operation mode (auto/cool/dry/fan/heat). : press it to increase temperature setting. : setting. Fan press it set swing angl...

  • Page 12

    Is displayed when pressing the air button.Press this button again to clear the display. Air icon: 25 this area will show the set tempe- rature. In save mode,"se" will be displayed. Digital display: 24 lock icon: is displayed by pressing "+" and “- ” buttons simultaneously. Press them again to clear ...

  • Page 13

    Isdisplayed when pressing the i feel button.Press this button again to clear the display. I feel icon: 30 is displayed when pressing the health button.Press this button health icon: 26 is displayed when pressing the n o t t u b s i h t s s e r p . N o t t u b o b r u t again to clear the display. Tu...

  • Page 14

    6 press this button to set up &down swing angle. Off this remote controller is universal . If any command , or is sent out, the unit will carry out the command as indicates the guide louver swings as: p ress this button to start the ventilatin system or generate cold plasma function. (the function i...

  • Page 15

    Light: 15 press light button to turn on the display's light and press this button again to turn off the display's light. If the light is turned on , is displayed. If the light is turned off, disappears. Sleep : 9 press this button to go into the sleep operation mode. Press it again to cancel this fu...

  • Page 16

    ȝ Ɣ Ɣ Ɣ Ɣ Ɣ 1.Remove the battery cover plate from the rear of the remo te controller. (as shown in the figure) 2.Take out t he old batteries. 3.Insert t wo new aaa1.5v dry batteries, and pay attention to the polarity. 4. Reinstall the battery cover plate. When repl acing the batt eries, do not use o...

  • Page 17

    Mode model temperature setting airflow rate auto cooling 25 ( cool,fan) auto auto heat ć ć ć pump 25 ( cool,fan) auto auto heat pump 20 ( hea t) auto emergency operation when the remote controller is lost or damaged, please use the manual switch on the main unit. In that case, the unit will operate ...

  • Page 18

    đ ? ? ? D )lje caution note: remove the front panel. Ș Ș Ș disconnect the power supply before cleaning and maintenance. Do not splash water on the units for cleaning, as electric shocks may occur dip a piece of cloth into the water colder than 45 and dry it . Then wipe the dirty part of front panel....

  • Page 19

    Ś be sure that nothing obstructs the air outlet and intake vents. ś Ŝ check the batteries of air conditioner uhprwhduhjrrg ŝ check that whether the installation eudfnhwvof the outdoor unit duhlqjrrgfrqglwlrq. If damaged, please contact the dealer. Ś ś Ŝ ŝ Ş clean and care check before use check that...

  • Page 20

    Once the air conditioner is stopped, it will not operate in approximately 3 minutes to protect itself. ƽ ƽ ƽ ƽ ƽ ƽ troubleshooting caution don't attempt to repair the air conditioner by yourself, it can cause an electric shock or fire. Please check the following items before asking for repair, it ca...

  • Page 21

    ƽ ƽ ƽ ƽ ƽ ƽ ƽ ƽ ƽ ƽ ƽ ƽ ƽ ƽ ƽ ƽ ƽ ƽ ƽ ƽ ƽ ƽ ƽ troubleshooting phenomenon troubleshooting the unit can not run. Has the power been shut down? Is power plug loosed? Is the circuit protection device tripped off or not? Is voltage higher or lower? (tested by qualified air conditioning engineer) is the t...

  • Page 22

    ƽ ƽ ƽ ƽ troubleshooting phenomenon troubleshooting indoor unit cannot deliver air . Moisture ln air outlet vent. If unit is running under the high humidity for a long time, the moisture will be condensed on the air outlet grill and drip off. Immediately stop all operations and plug out, contact the ...

  • Page 23

    Select a position where the condensing water can be easily drained out, and the place is easily connected for outdoor unit. Can select the place where is strong enough to withstand the full weight and vibration of the unit. And will not increase the noise. Make sure that the indoor unit installation...

  • Page 24

    Notices for installation safety requirements for electric appliances earthing requirements note: make sure hohfwulfzlulqjduhfduulhgrxwe\txdolilhghohfwulfldqv wrong connection may cause fire. ● ● 4. The min. Distance from the unit and yrodwlohvxevwdqfh is 1.5m. 1. The power supply should be used the ...

  • Page 25

    Space to the wall above above installation dimension diagram installation dimension diagram space to the ceiling space to the wall space to the wall air outlet side space to the floor above above above above above the dimensions of the space necessary for correct installation of the appliance includ...

  • Page 26

    Ø 55.0 845 275 542 131 256.8 124 50 Ø 55.0 50 100 installation of indoor unit installation of mounting plate 1. Mounting plate should be installed horizontally. As the water tray's outlet for the indoor unit is two-way type, during installation, the indoor unit should slightly slant to water tray's ...

  • Page 27

    Ɣ Ɣ Ɣ after tightening the screws, pull the wire slightly to confirm whether it's firm or not. Ɣ Ɣ make sure that all wiring connections are secure and the cover plates are reinstalled note: all wires between indoor and outdoor units must be connected by the qualified electric dlufrqglwlrqlqjhqjlqhh...

  • Page 28

    Installation of indoor unit ƽ Ł ł installation of indoor unit the piping can be output from right, right rear, left or left rear. When routing the piping and wiring from the left or right side of indoor unit, cut off the tailings from the chassis when necessary( as s hown fig.7) cut off the tailings...

  • Page 29

    Ø condensate drainage of outdoor unit (no for cooling only) the condensate and defrosting water formed during heating in the outdoor unit can be properly discharged by drainage pipe . Installation method:set the drain connection in 25 hole of the chassis has been installed and then connect drainage ...

  • Page 30

    Do not switch on power before installation is finished completely. Electric wiring must be connected correctly and securely. Cut-off valves of the connection pipes should be opened. Switch on power, press "on/off" button on the wireless remote control to start the operation. Check after installation...

  • Page 31: Service And Warranty

    Eco air guarantees this product free from defects in materials and workmanship for a period of one (1) year from the date of purchase. Coverage is valid only with proof of purchase. This unit must be operated under conditions as recommended, within the voltage range indicated on the unit. Any attemp...