1. DL manuals
  2. Ecoair
  3. Air Conditioner
  4. ECO12P
  5. Nstallation And Operations Manual

Ecoair ECO12P Nstallation And Operations Manual

Summary of ECO12P

  • Page 1

    In s ta ll a ti o n a n d o p e ra ti o n m a n u a l room air conditioners portable range eco12p register your air conditioner model information can be found on the ce label. Please register your product online at www.Ecoair.Org. For your future convenience, record the model information below. ____...

  • Page 2

    Congratulations! You have purchased the very latest in room air conditioner technology. Your new ecoair high efficiency room air conditioner will give you many years of dependable service. Many features have been built into your ecoair air conditioner to assure quiet operation, the best circulation ...

  • Page 3: Bs Plug Wiring

    Wiring instructions: should it be necessary to change the plug please note the wires in the mains lead are coloured in accordance with the following code: blue - neutral brown - live green and yellow - earth as the colours of the wires in the mains lead of this appliance may not correspond with the ...

  • Page 4

    -2- specification cooling capacity heating capacity power / ampere consumption for cooling power / ampere consumption for heating air volume (max. Speed) humidity removal capacity power supply compressor sound pressure sound power refrigerant fan speed timer working temperature exhaust pipe net weig...

  • Page 5

    Summary -3- working principle this compact and energy efficient air conditioning unit can be moved to different locations within your home or office. With its multiple functions of cool, heat, dry and fan, this versatile appliance is the perfect addition to any large space. Its low noise makes it an...

  • Page 6

    User notices install the unit in a well ventilated area, do not cover the unit. Do not keep the unit in direct sunlight. To avoid electrocution, do not install the unit in a damp area and keep away from water. Location make sure the unit is at least 1m away from any television sets. If the mains lea...

  • Page 7

    -5- before use general safety ‡21/ 326,7,2121$)/$7/(9(/ 685)$&($1'$7/($67fp )520$1 ‡'21273/$&(2%-(&76217+( 81,7255(675,&7$,5,1/(7287/(7 ),* ‡&/26(/ &+,/'5(1$1'3(76:+(17+(81,7 ,6,186( ‡7+,6$33/,$1&(,6127,17(1'(' )2586(% &+,/'5(1:,7+5('8&(' 3+ &$3$%,/,7,(625/$&.2) (;3(5,(1&($1'.12:/('*( 81/(667+( 683(...

  • Page 8

    -6- structure front rear remote control receiver air outlet handle upper air inlet grille heat air exhaust vent power cord lower air inlet grille control panel.

  • Page 9

    Operating methods -7- placement requirements: ※. Usage notice unpack the air conditioner remove packaging materials remove unit from box (packaging). Remove tape and glue residue from surfaces before turning on warning excessive weight hazard two or more people are required to move and install the a...

  • Page 10

    -8- operating methods names and functions of the control panel 1.Power on / off: press once to start and press once more to stop the unit. 2.Mode: press this button to change the operation mode in order of: &22/ĺ'5 3. " " " " : press" " once, the temperature will increase 1℃.The temperature can be s...

  • Page 11

    1). Select a place near a door or window, install the exhaust duct. 2). Press "mode" key to select "cool" mode. Please close the door and windows to obtain the best dehumidifying effect: press "mode" key, select the "dry" mode, the unit will run in the "dry" mode, at the same time, the upper motor i...

  • Page 12

    Names and functions of the remote control fan auto oper health air filter turbo on/off x-fan hour humidity on/off mode fan x-fan turbo temp timer sleep light 2 11 7 10 13 9 4 3 12 8 6 14 5 1 press it to start or stop on/off operation. Mode + - press to select operation mode (auto/cool/dry/fan/heat)....

  • Page 13

    -11 - names and functions of the remote control fan auto oper health air filter turbo on/off x-fan hour humidity 19 15 20 18 16 17 21 22 23 24 lock icon: mode icon: light icon: if mode button is pressed, current operation mode icon pressing temp button, (set temperature), ambient temperature) (outdo...

  • Page 14

    -12- operation of the remote control remote control description 1 2 4 3 5 press this button to turn on the unit . Press this button again to turn off the unit. Each time you press this button,a mode is selected in a sequence that goes from auto, cool, dry, fan,and heat * , as the following: auto coo...

  • Page 15

    - 13 - operation of the remote control 10 temp: press the health part of this button to turn the health function on or off. 7 health save (optional): press timer button at unit on to set timer off; hour off blinks. Press timer button at unit off to set timer on; hour on blinks. In this case, pressin...

  • Page 16

    -14- operation of the remote control sleep : light: 13 14 replacement of batteries ȝ Ɣ Ɣ Ɣ Ɣ Ɣ 1.Remove the battery cover plate from the rear of the remote controller. (as shown in the figure) 2.Take out the old batteries. 3.Insert two new aaa1.5v dry batteries, and pay attention to the polarity. 4....

  • Page 17

    Accessories and installation of heat exhaust hose -15- Ɣ length range of the exhaust pipe should be 50 – 150cm. It is recommended to use it with the shortest length. Ɣ when installing, the exhaust pipe should be as flat as possible. Do not stretch the pipe or connect it with another exhaust pipe. Th...

  • Page 18

    Accessories and installation of heat exhaust hose 55cm -16- if the pipe has to be bent, please consider the following dimensions when installing an incorrect installation is shown in the following figure (if the pipe is bent too much, it could easily cause a malfunction). 55cm 65cm.

  • Page 19

    -17- accessories and installation of heat exhaust hose parts included eco12p unit & the following accessories: window exhaust adapter flexible exhaust hose front plastic pipe end remote control real grill baffle plate adjusting plate drain hose back plate back plate installation and operation manual.

  • Page 20

    Projection window panel -18- foam seal a (adhesive type) 1 attach the guard combined above to the window panel push the insect guard net firmly to ensure that its four projections fit into the holes in the window panel. 2 cut the foam seal a (adhesive type) to the correct length and attach it to the...

  • Page 21

    Foam seal a (adhesive type) adjustment panel extension panel -19- if the inner width of the window is between 24" (609mm) and 36.8" (934mm) inclusive. (1) open the window sash and place the window panel on the window sill. (2) slide the adjustment panel to fit the window frame width. (3) secure the ...

  • Page 22

    Installation in a sliding sash window projection window panel -20- 1 attach the guard combined above to the window panel. Push the insect guard net firmly to ensure that its four projections fit into the holes in the window panel. 2 cut the foam seal a (adhesive type) to the correct length and attac...

  • Page 23

    If the inner height of the window is b e t w e e n 2 4 " ( 6 0 9 m m ) a n d 3 6 . 8 " (934mm) inclusive. (1) open the window sash and place the window panel on the window frame. (2) slide the adjustment panel to fit the window frame height. (3) secure the window panel to the window frame with 3 scr...

  • Page 24

    4 cut the foam seals (adhesive type) a and b to the proper length and attach them to the window panel. Attach foam seal a to the window panel and extension panel, and attach foam seal b to the adjustment panel. 5 close the window sash securely against the window panel. 6 cut the foam seal to an appr...

  • Page 25

    Installation instructions install rear clip — aim the rear clip (upper) at the rear clip (lower), fix them together, press the clasp forcibly in to the groove. Install the hose at the rear clip — aim the opening of hose at the round mouth of rear clip, rotate the hose anticlockwise into the rear cli...

  • Page 26

    Installation instructions the length of rear plate 1 and rear plate 2 can be adjusted according to user’s requirement. Loosen the screws fixing the rear plate 1, rear plate 2 and adjustable plate to move the rear plate 2 and adjustable plate (can slide freely in the sliding groove of rear plate 1 an...

  • Page 27

    Installation instructions install exhaust hose assembly to the rear as in picture 1. Simply slot joint 1 downwards on the air outlet picture 2. Air outlet groove of back plate joint 1 baffle (air outlet) when the unit is not in use and using the window kit remove hose and close the grille with the "...

  • Page 28

    Installation instructions -26- filter 2 — hold the buckle of filter 2 to pull it outwards. Install cable hook — press the clasp at the upper side of back plate, assemble the first cable hook downwards into the groove of upper clasp; press the clasp at the lower side of back plate, assemble the secon...

  • Page 29

    Installation of drainage hose (as shown in the following figure): note: the drainage hose must be installed before operating the unit otherwise a blockage may occur affecting the normal operation of the unit. 1. Remove drain cap (a) from drain port (b). 6. During the process of cooling , excess cond...

  • Page 30

    Warning -28- care and maintenance Ɣ draw out filter supporter and take out filter Ɣ wash the filter with a soapy spray. And shake it, or immerse it into gentle soapy water, then drip it in the shade. Casters underneath the unit enable it to be moved easily within a room. Mobile unit air inlet grille...

  • Page 31

    -29- care and maintenance electric schematic diagram clean the air conditioner please use a cloth that is slightly moistened with water at a temperature below 40 °c . Do not use gasoline, diesel oil or a congeneric substance to clean the unit. Before cleaning, please pull out the power plug. Ga s ec...

  • Page 32

    If malfunctions occur, please check the following before maintenance: troubles the air conditioner doesn't start. Although it was set to cool mode, there is no cool air. Although it was set to dry mode, there is no cool air. The led displays" ". The led displays" ". Possible causes the power supply ...

  • Page 33

    After sales service Ɣ if any quality problems or any other problems exist, please contact your dealer. -31- Ɣ meaning of crossed-out wheeled unit: do not dispose of electrical appliances as unsorted municipal waste, use separate collection facilities. Ɣ contact you local council for information rega...

  • Page 34: Post Order Form

    Post order form your details company name: name: address: post code: telephone: mobile: fax / email: payment details (please tick one below) credit or debit card or cheque visa master card solo visa electron card number: name on card: issue date: / expiry date: / issue no (where applicable): / card ...

  • Page 35: Service And Warranty

    Ecoair guarantees this product free from defects in materials and workmanship for a period of one (1) year from the date of purchase. Coverage is valid only with proof of purchase. This unit must be operated under conditions as recommended, within the voltage range indicated on the unit. Any attempt...