- DL manuals
- Ecom Instruments
- Cell Phone
- Ex-GSM 01 EU
- Operating Instructions Manual
Ecom Instruments Ex-GSM 01 EU Operating Instructions Manual
Summary of Ex-GSM 01 EU
Page 1
Operating instructions ex-gsm 01 eu.
Page 2
The device ecom model ex-gsm 01 is based on the device nokia mobile phone model 5140i. This mobile phone has been subjected to technical modifications by ecom instruments gmbh for use in potential explosive areas. Ecom instruments gmbh takes sole responsibility for any risks and damage in connection...
Page 3
44 table of contents 1. Application 46 2. Safety instructions 46 3. Errors and load restrictions 46 4. Safety regulations 47 5. Ex-data 47 6. Technical data 48 7. Functional description / operating information 48 7.1 initial steps 48 7.1.1 installing the sim card and rechargeable battery 48 7.1.2 ch...
Page 4
45 7.7.8 telephone 63 7.7.9 security 64 7.7.10 re-establishing the factory settings 65 7.8 push-to-talk 65 7.8.1 push-to-talk menu 65 7.8.2 push-to-talk calls 66 7.8.3 call back requests 68 7.8.4 setting up groups 68 7.8.5 ptt settings 70 7.9 organizer 71 7.9.1 alarm 71 7.9.2 calendar 71 7.9.3 task ...
Page 5
46 1. Application the ex-gsm 01 is a limited energy, non-sparking, splash-, dust- and shock-proof mobile telephone designed for industrial use in potentially explosive areas of zones 2 and 22 (cat. 3 gd, for non-conductive dusts only) in accordance with directive 1999/92/ec (atex 137) or 1994/9/ec (...
Page 6
47 4. Safety regulations persons using the explosion-protected ex-gsm 01 mobile telephone must observe the standard safety regulations and read the certificate to prevent incorrect operation or misuse of the unit. The following safety regulations must be observed in addition: - the unit must not be ...
Page 7
48 approved for zone 2, device group ii, explosion group iic (potentially explosive gases, vapours or mist), temperature class t6. Approved for zone 22, device group ii, dust ex-atmosphere, max. Surface temperature (- for surfaces on which dust can accumulate) +75°c, housing protects against dust de...
Page 8
49 this unit is designed for use with a rechargeable battery type ex-am gsm 01. Please be sure to only use this type of rechargeable battery. The sim card and contact surfaces can be easily damaged if scratched or bent. Therefore, please handle the card carefully and take extra pre- caution when ins...
Page 9
50 close the cover of the sim card holder (8). Push the cover of the sim card holder toward the upper end of the telephone until it engages (9). Align the contacts of the battery to the gold contacts and insert it into the tele- phone. With the contacts entering first, push the battery into the batt...
Page 10
51 7.1.3 turning the telephone on and off warning : do not turn the telephone on if the use of mobile telephones is prohibited; it could result in interference or pose hazards. Hold down the on/off button. When asked to enter the pin or upin code, please enter it here (displayed as ****), and select...
Page 11
52 • end button (9) for ending a call or a function. • the 0—9 keys are used for entering numbers and characters (10). • the * and # keys are used for different purposes in different operations. • connection for the charger (1) • pop-port tm connection, e.G. For headset and data cable (2) • camera l...
Page 12
53 online is selected and the package data service is available. A package data connection is established. A package data connection is interrupted, if for example an incoming or outgoing call is taking place. This display is on continuously if an infrared connection has been established. 7.2.3 keyp...
Page 13
54 to refuse an incoming call, press the button for ending a call. To switch the ring tone to silent, press silent . You can then either accept or refuse the call. 7.3.3 options during the call many of the options that you can use during a call are network services. You can obtain information about ...
Page 14
55 7.4.1 settings to change the language, select the option > input language . Predictive text input is only available for the specified languages. Select the option > dictionary on for predictive text input or dictionary off for the traditional text input. 7.4.2 predictive text input predictive tex...
Page 15
56 7.5 messages the message services can only be used if they are supported by your network or your provider. 7.5.1 short message (sms) with the short message service (sms), you can send and receive extra long messages linked to each other, which consist of several normal short messages (network ser...
Page 16
57 to activate the e-mail settings, select menu > messages > message setting > e-mail messages. . This application does not support key tones. Composing and sending e-mails 1. Select menu > messages > e-mail > create e-mail . 2. Enter the e-mail address of the recipient, a subject and the message. T...
Page 17
58 7.6.1 search by name select menu > address book > name > option > search . Scroll through the list of names or enter the first letter of the name you are searching for. 7.6.2 saving, copying and deleting entries names and telephone numbers are stored in the respective memory being used. Select me...
Page 18
59 7.7 settings 7.7.1 profiles the telephone has various setting modes, so-called “profiles”, which al- low you to adjust the telephone rings for certain events and environments. Select menu > settings > profiles . Scroll to the desired profile and select it. To activate the desired profile, select ...
Page 19
60 7.7.4 display select menu > settings > display and one of the following options: background , to add a background image to the display in the initial dis- play. To select, activate or deactivate the background image, chose select background > on or off . To download additional background images, ...
Page 20
61 7.7.6 connections you can connect the telephone to compatible devices via infrared. You can also arrange the settings for gprs dial-in connections. Infrared the telephone can be configured for sending and receiving data via its infrared connection (ir). To use an ir connection, the other device m...
Page 21
62 select as required , to set up the package data connection when it is nee- ded by a program. It will be disconnected when the program is ended. Select always online to set the telephone so that a connection to a pa- ckage data network is automatically established when the phone is turned on. Mode...
Page 22
63 call waiting > activate , to request that you be informed by the network of an incoming call during an active call (network service). Show cost/length of time > on, to briefly show the approximate length of time and cost of the call after calling (network service) . Send own number (network servi...
Page 23
64 help texts , to specify whether help texts are to be displayed on the tele- phone. Start melody , to select whether the telephone will play a start melody when it is turned on. 7.7.9 security when security functions which restrict the calls (such as call blocking, calls only to closed user groups...
Page 24
65 7.7.10 re-establishing the factory settings to re-establish certain menu settings to their original values, select menu > settings > re-establish factory settings . Enter the security code. The will ensure that the entered or downloaded data such as: the names and telephone numbers stored in the ...
Page 25
66 • to specify the ptt settings to be used, select the ptt settings. • to specify the settings required for the ptt connection, select config.Settings . • to open the browser and establish a connection to the ptt network portal of the provider, select internet. 7.8.2 push-to-talk calls set the loud...
Page 26
67 making a group call press the ptt button to make a call to the standard group. A tone signal indicates that access has been granted and the telephone displays your nickname and your group name. To make a call to a group other than the standard group, select the group list option in the ptt menu, ...
Page 27
68 7.8.3 call back requests if you do not receive an answer to an individual call, you can send the respective person a call back request. If you receive a call back request from another person, the message “call back request received” appears in the initial display. If the call back request comes f...
Page 28
69 the groups are registered via a url address. A user registers the group url in the network by initially joining the group meeting. There are three types of ptt groups: • provided groups are closed groups to whom only the participants selected by the provider are admitted. • ad hoc groups are grou...
Page 29
70 2. To display the nickname of the inviting party and the group address (if it does not pertain to a private group), select show . 3. To add the group to your telephone, select save .. To specify the status of the group, select standard, monitor or inactive . To decline the invitati on, select end...
Page 30
71 7.9 organizer 7.9.1 alarm the telephone can be set so that it sets off the alarm function at a specific time of day. Select menu > organizer > alarm . To set the alarm, select alarm time , and enter the alarm time. To change an alarm time already specified, select on . To set the telephone so tha...
Page 31
72 when displaying an entry, you also have the option to edit the deadline or the priority or to mark the task as completed. 7.9.4 notes if you would like to use this application for composing and sending notes, select menu > organizer > notes . If there is no entry yet, you can create an entry by s...
Page 32
73 7.9.6 synchronization using the synchronization function, you can save the data in your address book to a remote internet server (network service) or a compatible pc. After you have saved the data to the remote internet server, start synchro- nization from your telephone to synchronize this data ...
Page 33
74 account , to select a synchronization service account from the active configuration settings. 2. Select pc synchronization settings to enter the user name and pass word for the synchronization instigated by the server. Specify the settings for user name and password. The user name and password fo...
Page 34
75 7.10.3 data communications applications information on the use of data communications applications can be found in the documentation of the respective application. You should not place or receive any calls while it is connected to a pc. This could disrupt the performance. For better power during ...
Page 35
76 do not short circuit the battery module! Dispose of the battery module in compliance with local provisions. Do not throw the battery module away with the normal household trash. 10. Information on certification (sar) this unit complies with the international guidelines for shielding electromagnet...
Page 36
77 11. Repairs repair work is subject to the nationally valid regulations and directives. Repairs have to be carried out at ecom instruments gmbh to ensure that it is inspected for safety and reliability. 12. Disposal electrical devices and „historic“ electrical devices of ecom instruments gmbh are ...
Page 37
78 all of the above tips also apply for your unit, battery, charger and all ac- cessories. If your unit does not function properly, send it to the manufac- turer. 14. Service & maintenance we recommended having the functions and the measures provided for explosion protection checked by the manufactu...
Page 38
79 16. Ec declaration of conformity further details relating to the declaration of conformity can be found at the following internet address: http://www.Ecom-ex.Com in the download area..
Page 39
80 17. Type examination certificate.
Page 40
81.
Page 41
82.
Page 42
Ecom instruments gmbh · industriestr. 2 · 97959 assamstadt · germany tel.: + 49 (0) 62 94 / 42 24 0 · fax: + 49 (0) 62 94 / 42 24 90 e-mail: sales@ecom-ex.Com · www.Ecom-ex.Com weee-reg.-nr. De 934 99306 0164al01 a00 07/06 Änderungen vorbehalten! Subject to change without notice! Communication torch...