- DL manuals
- Ecomax
- Dishwasher
- CLF 26
- Installation & Operation Manual
Ecomax CLF 26 Installation & Operation Manual
Summary of CLF 26
Page 1
Manuals and instructions brought to your courtesy of wechillit.Com ltd sales team : 01743 284918.
Page 2: Clf 26
Clf 26 installation & operation.
Page 3: Contents
- contents general information ______________________________________________________ 2 1. Documentation supplied with the machine ____________________________________________ 2 2. General notes ___________________________________________________________________ 2 3. Important safety notes _________...
Page 4: General Information
General information page 2 general information f ailure to comply with the instructions provided may compromise the safety of the appliance and will invalidate the warranty with immediate effect . 1. Documentation supplied with the machine this manual contains important information regarding safety ...
Page 5
General information page 3 3. Important safety notes the appliance is designed for professional use and notwithstanding the manufacturer’s efforts to simplify its operation, installation and maintenance, the appliance is designed for operation by trained personnel in compliance with the manufacturer...
Page 6
Getting to know your machine page 4 getting to know your machine 1. Control panel [1] = power on/off switch and pilot light» [2] = start button [3] = “wash cycle” pilot light [4] = “heating” pilot light [5] = cold rinse (optional) [6] = drain pump (optional) [7] = cycle selection (optional) 2. Insta...
Page 7: Installation
Installation page 5 installation t he manufacturer accepts no liability for any damage to objects or personal injury arising from installations which fail to comply with the instructions provided . 1. Glossary in this document, the terms main switch, water supply stop cock and drain line are defined...
Page 8
Installation page 6 2. Unpacking the appliance before removing the packaging, check for any signs of damage, noting any defects found on the carrier’s delivery note after removing the packaging inspect the appliance for signs of damage; if damaged, notify your dealer by fax or registered post immedi...
Page 9
Installation page 7 ii water supply a water supply pipe with a “stop cock” (see “glossary”) must be provided for each machine. The water supply line must conform to the specifications indicated in the section “installation data”, even when other appliances are connected to the supply line. If the wa...
Page 10
Installation page 8 5. Dispenser settings i rinse-aid dispenser before starting the washing cycle, the dispenser and the delivery pipe must be full. Check that there is sufficient rinse-aid in the container and top up if necessary. The rinse-aid container must never be allowed to empty completely an...
Page 11
Installation page 9 not lead to any significant improvement. To remove this patina, the tableware is to be left to soak in a water and soap solution (10:1) for about 30 minutes and then washed again. Ii detergent dispenser (optional) never allow the detergent container to empty completely and never ...
Page 12
Installation page 10 on completion of the filling cycle and before the wash cycle has started, open the door and pour the previously determined quantity of detergent into the chamber in the region of the wash pump suction filter. About 10 seconds after the start of the wash cycle, start turning the ...
Page 13: Use and Maintenance
Use and maintenance page 11 use and maintenance 1. Safety notes t he manufacturer accepts no liability for any damage to objects or personal injury arising from failure to comply with the instructions provided . I precautions the correct operation and the service life of the appliance depend on exte...
Page 14
Use and maintenance page 12 iv hygiene to ensure the hygiene of the machine, it is important to carry out the periodic maintenance operations indicated in the relative section of this manual. The appliance must also be regularly sanitized using suitable non-corrosive commercial products. The interna...
Page 15
Use and maintenance page 13 before starting the machine, check that it has been installed correctly by a qualified technician in compliance with all the indications contained in the documentation supplied with the appliance. Dispensers for rinse-aid and detergent (optional) before starting the wash ...
Page 16
Use and maintenance page 14 6. Only load items which are guaranteed suitable for dishwashers and which are free from cracks. 7. Load the rack into the appliance and close the door. 8. Select the desired cycle with button [7]. Press button [2] to start the wash cycle. 9. Light [3] will illuminate to ...
Page 17
Use and maintenance page 15 for appliances without detergent dispensers only. If five cycles have already been performed, add detergent in the region of the washing pump suction filter in the amount indicated by the detergent manufacturer and the installation manual. Follow the instructions given fo...
Page 18
Use and maintenance page 16 • clean the machine using a damp rag with a little detergent. • do not use scouring pads, wire brushes or abrasive cleaning products to clean the steel surfaces. If the machine is not to be used for a period, leave the door slightly ajar to prevent unpleasant odors from f...
Page 19
Use and maintenance page 1 7 8 . Solutions to the most common problems i dishes not clean p roblem r emedy wash arms stuck. The arms should rotate easily by hand. Pull arms off and clean carefully. Check and clean the arms supply pipe in the machine. Nozzles of spray arms obstructed remove the spray...
Page 20
Use and maintenance page 18 iii water softener (optional) p roblem r emedy excess salt in rinse water. Salt left in container after regeneration. Only fill container immediately before starting the regeneration cycle with the quantity of salt indicated in the operating instructions. Wrong size salt ...
Page 21
D m6 109 139 y7 e b11 c2 m4 109 f g a b b b f y5 109 n01 123 m3 s3 151 102 109 151 n03 n02 c n03 e1 e3 b3 pe n l3 l2 br bk 201 204 203 205 202 b1 h4 n01 122 116 114 115 110 137 101 bl l1 c1 ml k11 b10 b5 s1 mv k4 a1 1 k4 a1 a1 m1 y2 h3 116 a1 2 3 a1 4 a1 k4 s16 f1 109 k4 120 122 n01 111 116 116 122 ...
Page 22
Gb d f i e p a1 cycle timer programmschaltwerk programmateur de cycle timer ciclo programador de ciclo programador ciclo b1 boiler thermostat temperaturbegrenzer durchlauferhitzer thermostat surchauffeur termostato boiler termostato del calderin regolador de temperatura caldeira b3 tank thermostat t...
Page 23
Dishwasher technical specifications chg25 chf40 chh50 clg25 clf26 drain size 20mm 22mm 50mm 18mm 22mm drain hose length 2,5m 1,5m 1,80m 1,5m 1,5m water connection 3/4" 3/4" 3/4" 3/4" 3/4" water hose length 1,5m 1,5m 2m 1,5m 1,5mt water pressure 1-4bar 1-4bar 1-4bar 1-4bar 1-4bar water temp 50-55c 15...
Page 24
As continued product improvement is a policy of hobart, specifications are subject to change without notice. Ce catalogue n’est pas contractuel. Hobart se réserve le droit, et sans préavis, d’apporter toutes modifications ou améliorations à ses matériels. Hobart behält sich das recht vor, an allen p...