1. DL manuals
  2. Ecopower Heating
  3. Heater
  4. VANTAGE NEHV06
  5. Installation And User Manual

Ecopower Heating VANTAGE NEHV06 Installation And User Manual

Summary of VANTAGE NEHV06

  • Page 1

    Ist 03 f 079 - 01 electric heating expert, gateway house, kings parade, kings road, fleet, hampshire, gu51 3ab. Phone number: 01252 560770. Website: www.Electricheatingexpert.Co.Uk..

  • Page 2

    2 dear customer, we thank you for your confidence. Before installing and/or using the product, please read carefully this manual concerning the correct installation, use and maintenance of the appliance. We remind you as well that this manual must accompany the radiator in case of transfer to anothe...

  • Page 3

    3 1. Warnings the symbol shown here appears on a label on the radiator, whose meaning is: to avoid the overheating of the appliance, do not cover the radiator with clothes or other objects. The radiator shall in no case: - be covered in part or in full - be in direct contact or too close to curtains...

  • Page 4

    4 this appliance is filled with a precise quantity of oil. Any reparations requiring the opening of the oil tank must be carried out only by the manufacturer or its technicians, that should be contacted in case of oil leaks; when the appliance is scrapped, it is necessary to comply with regulations ...

  • Page 5

    5 fig. 1 in the bathroom, protect the power line with a high sensitivity 30 ma differential protection device install a multipolar switching device. The minimum separation distance between contacts shall be at least 3 mm. 3. Installation of the appliance to achieve the best results in terms of heat ...

  • Page 6

    6 3.1. Radiator wall mounting the radiator must be fastened to a wall through the suitable mounting brackets provided with the product. The fastening system is composed of: using adhesive tape, stick the template supplied in the desired position and mark the position of the holes, then remove the te...

  • Page 7

    7 without any template, mark the position of the holes according to the indications of the following tables: then follow the steps illustrated below: number of sections/power 5/600 w 6/1000 w 9/1200 w 10/1500 w 12/1800 w dimension a 239 mm 319 mm 558 mm 558 mm 797 mm 1 1. Drill as indicated by the h...

  • Page 8

    8 3. Position "b" upper plastic parts of the bracket. 4. Fit the two "c" lower clamps and rotate them until you hear a first click. Electric heating expert, gateway house, kings parade, kings road, fleet, hampshire, gu51 3ab. Phone number: 01252 560770. Website: www.Electricheatingexpert.Co.Uk..

  • Page 9

    9 5. Position the radiator by leaning it on the upper part of the brackets and then rotating it. Push the radiator until it is automatically locked by lower plastic clamps. 6. If necessary, remove the radiator and operate on the lower plastic clamps by moving them horizontally and then rotating them...

  • Page 10

    10 the display contains the icons shown below, and they are switched on from time to time according to the state of the radiator: 4.2. User functions this radiator is equipped with several functions and operating modes that the user can select through the “function” key. Operating modes provided: co...

  • Page 11

    11 4.2.1. Description of functions pilot wire mode (for france only). In this mode the radiator is controlled by a remote control unit. 1. Press the “function” key until the relevant key is displayed. 2. Select the desired temperature using “+” and “-” keys. The operating mode is selected by the pil...

  • Page 12

    12 boost mode this function can be used to heat up the rooms as fast as possible. 1. Press the “function” key until the relevant key is displayed. 2. With “+” and “-” keys it is possible to select the duration of the boost period, from 5 to 120 minutes. When this function is active, the radiator wor...

  • Page 13

    13 when the function is activated and detected at window opening, the displayed symbol of the window is intermittent. When the function is deactivated the symbol of the window is not displayed. The user can activate or deactivate this function as follows: 1. Switch the radiator to standby state. 2. ...

  • Page 14

    14 key lock function it is possible to lock the device to avoid an improper or unintentional use, for instance for children protection or in a public space. To lock/release the keys press "function" key and hold for about three seconds. In this way the keyboard is locked/released. Note: it is possib...

  • Page 15

    15 4.3.1. Setting of current day and time 1. Switch the radiator to standby state. 2. Press and hold "programming" key for more than 3 seconds: the display shows "prog", meaning programming or "ted", meaning time and date. 3. With "+" key it is possible to switch from "prog" to "ted" selection. 4. W...

  • Page 16

    16 table of technical faults problem state of the radiator probable cause solution radiator is not working properly “all” is displayed the temperature sensor is faulty contact a service centre the radiator does not heat up the display does not show any notice no power supply check the presence of ma...

  • Page 17

    17 7. Warranty the body in aluminium alloy is warranted against manufacturing defects for 10 years from date of purchase. Electric and electronic components are warranted for 2 years from the date of purchase of the radiator. To validate your warranty, it is necessary to produce a document attesting...

  • Page 18

    18 input voltage 230v ac 50 hz mod. Nehv06 600 w mod. Nehv10 1000 w mod. Nehv12 1200 w mod. Nehv15 1500 w mod. Nehv18 1800 w insulation class class ii water protection class ip24 working temperature 0 ÷ 50 °c consumption in standby mode storage temperature -20 ÷ 70 °c working relative humidity 0 ÷ 8...

  • Page 19: Declaration of Conformity

    19 declaration of conformity we hereby declare for ecopower heating ltd 252 high street aldershot hampshire gu12 4lp that electrical radiators for heating model vantage are manufactured according to european directives and european regulations: - direttiva 2006/95/ec : “bassa tensione” - direttiva 2...

  • Page 20

    The manufacturer reserves the right to modify the products as it deems necessary and useful, without affecting their basic features. Ist 03 f 079 - 01 luglio 2015 (07/2015) 0zlibist87.