Ozone blaster 2 by ecoquest 3500/7000 mg/hr. Ozone generator commercial air purifier owner’s manual please read all of the information provided in this owner’s manual before operating your new commercial air purifier..
Caution risk of electrical shock do not open attention caution: to reduce the risk of electrical shock, do not remove cover. No user serviceable parts inside. Refer servicing to qualified servce personnel. This “bolt of lightning” indicates that uninsulated material within your unit may cause an ele...
Introduction this commercial air purifier is an advanced and convenient contaminant remediation product. High-powered oxidation in a compact, lightweight, rugged and simple design. Utilizing controlled corona discharge ozone technology developed specifically to reduce odors and smoke in unoccupied s...
Operating your ozone blaster 2 (front view) timer control knob turn clockwise to set the timer for timed operation up to two hours . Indicator light illuminates when unit is in operation. High-low switch ozone high and low change-over switch.
(back view) fuse holder houses removable fuse. (two amp, 0.79 inch in length) power cord grounded cord.
Ozone blaster 2 removes odors, bacteria, mold and viruses in unoccupied spaces. The unit has a timer that will enable it to run for a maximum duration of 2 hours. The timer will then shut the purifier off. To operate the ozone generator air purifier: close off the desired area to be treated. rem...
When your ozone blaster 2 no longer produces enough ozone, replace the ozone plates . (usual replacement after 6000 hours of operation) how to replace the ozone plate: 1) turn the unit off and unplug from outlet. 2) use a screwdriver to unfasten cover screw and remove cover. 3) pull ceramic plate ou...
If you suspect a problem with your unit check the following: 1) unit plugged in properly. 2) unit is properly grounded to avoid potential shock. 3) fuse is installed properly and in good condition. To replace fuse, pull out the plastic fuse holder, remove old fuse and insert new fuse. Replacement fu...
