Ecor-Pro LD800 Instruction Manual - page 5
HOW IT WORKS
Your ECOR PRO
LD
800
dehumidifier controls the Relative Humidity by passing the air
through the unit forcing the excess moisture to condensate over a cooling heat
exchanger. This condensate water flows safely into a fixed drain.
The dried air then passes through a final heat exchanger where it is warmed before it
re-enters the area at a slightly elevated temperature.
The level of dehumidifying is set withe a digital humidistat control.
(not supplied). Ideal humidity is defined as being between 40-60%
(Relaltive Humidity) on an average annual base.
C= 100%
M= 43%
Use in black and white:
Use in full colours:
K= 100%
K= 65%
K= 100%
K= 65%
Pantone 300
Use in two colours:
K= 100%
Pantone 300
K= 65%
C= 100%
M= 43%
K= 65%
40% RH - 60% RH
Points to consider before installation:
- Fresh air Intake (ø 150 mm)
- Inlet moist air (ø 250 mm)
- Changeable air filter – Filter must be placed
- Drain - Drainage tube connection point (female 3/4” - 19 mm)
- Rear outlet (ø 250 mm) - Warmer, dried and cleaner air
- 2nd outlet (optional) - Easy to fit additional duct if desired
- Connecting a controller (optional) - see next page
- Connecting to the mains (refer to the rating plate)
Fresh air
intake
Moist air
intake
Fan
Drain
Compressor
Warmer, dried
and cleaned air
Warming heat exchanger
Cooling heat exchanger
Changable hepa filter
2nd outlet (optional)
Rear outlet
Mains
For the most efficient use, outside doors and windows should be kept closed
when the dehumidifier is operating.
5