EcoReco M series Owner's Manual - page 11
Throttle lever
Power button
Mode Selection button
Speedometer
Battery status
DASHBOARD AND THROTTLE UNIT
1.
2.
3.
4.
5.
Note
Warning
Throttle lever:
The scooter is equipped with Safe-Start protection to
limit uninrended jerking; you must first “roll” the
scooter manually to gain initial speed before the
throttle lever becomes activated. Place your finger(s)
over the throttle lever and squeeze as desired to
accelerate.
Power button:
Press for about 2 seconds to power on and about 1 second to power off.
Mode selection button:
Press the “mode” button as needed to switch among the following functions in sequence.
(a) TRIP: Distance traveled since last resetting the display.
(To reset, hold down the “mode” button until the display flashes twice.)
(b) ODO: Odometer to show total distance traveled.
(c) Numerical Speedometer: (Current velocity of the scooter, it shows “0” when standstill)
(d) Charging Cycle Counter.
There are total 5 bars indicating the current battery level. Each represents 16% of battery capacity.
When the battery level indicator is flashing and shows zero bars, the battery level is low (16% capacity
left). You can continue to operate the scooter for some time, but should charge it soon.
The dashboard unit would shut down automatically when the battery drains below 3% to prevent from
deep discharging .
Speedometer:
Graphic bars display the current speed in miles per hour (mph).
For quality assurance, an EcoReco scooter must go through several test rides and charging cycles.
Therefore, the 0D0 and Charging Counter modes might display miles ridden and charging cycles upon
receipt.
Press and hold the “mode” button at the cycle counter mode to change the unit system from imperial to
metric. A blinking “SET” and 001 indicates the unit is miles per hour (mph). Click the “mode” button
again can switch to kilometers per hour (KPH) (000). Holding the mode button for 3 more seconds sets it.
After emergent stops, it takes about 1-2 seconds to re-calibrate the zero
speed. The Safe-Start feature does not kick-in during this period, so you
may still accelerate the scooter if pulling the trigger. Please make sure
the scooter completely stops for more than few secs, if you would like
the Safe-Start feature to function again.
Battery status: miles per hour (mph).
7