EcoSeb DD122EA CLASSIC Instructions Manual - Empty Water Tank
© 2014 EcoSeb, Inc. 6 All rights reserved
E
n
g
li
sh
EMPTY WATER TANK
1.
The Water Full Indicator lights up when the water tank is full and the unit stops opera+ng in a
few minutes.
2.
Do not move the unit or remove the water tank when the dehumidifier is s+ll running, as wa-
ter may leak; causing damages to the dehumidifier or an electric shock.
3.
Before removing the water tank leave the unit to stand for approximately 10 minutes to en-
sure all water collected drips into the water tank.
4.
To remove the water tank, pull it out gently by gripping the bo5om of the water tank, and li:
carefully by the handle.
5.
Remove the cover of the water tank, then pour the water away. Clean the water tank, restore
the cover and handle.
6.
Insert the water tank back into to the correct posi+on.
NOTE :
•
Clean the water tank with clean water if needed. Do not use detergent, solvent, abrasive
or hot water to avoid damaging the dehumidifier.
•
Do not remove or damage the float in the water tank or the unit will not operate properly.
•
The Water Full light indicator illuminates if the water tank is not correctly in posi+on.
•
Do not +lt the dehumidifier when removing the water tank.
You may use a hose with an inner diameter of 7/16” for con+nuous drainage:
1.
Use a screwdriver to remove the knockout at the back. A5ach the hose to the connector
through the hole.
2.
The hose must lead to an appropriate drain at a downward slope with no sharp bends.
NOTE:
•
Ensure the water tank is well fi5ed in posi+on before inser+ng the hose.
•
Before removing the water tank, ensure that the hose is disconnected.
CONTINUOUS DRAINAGE
Pull water tank out
Li: by the handle
Remove the cover
Pour the water away
Restore the cover and
the handle
Insert the water tank
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
STEP 1
Knockout
STEP 2
Hose
STEP 3
Hose