EcoSmart ECO 16 Installation Instructions Manual - page 4
THIS PRODUCT IS DESIGNED TO BE INSTALLED INDOORS ONLY.
THE FOLLOWING SHOULD BE CONSIDERED WHEN SELECTING A LOCATION IN WHICH TO INSTALL THE HEATER:
●
The existing plumbing configuration. It is preferable to mount the unit in a location which will not
require major plumbing alterations.
●
The location of the main electrical panel. Mounting the unit in close proximity to the main electrical panel
will reduce the quantity of wire needed for installation.
●
Locations of the kitchen, bathrooms, and laundry area. Ideally the water heater should be installed near
the hot water applications (such as faucets or showers) which are used the most frequently. This will
allow for the most rapid delivery of hot water on demand.
●
Ease of access to the unit for service. Do not install the water heater in a location which is difficult to
access for maintenance or to adjust the thermostat setting. Typically, the tankless hot water heater will
be mounted near the location of the previous tank hot water heater. This product does not require
venting.
SAFETY PRECAUTIONS FOR SELECTING AN INSTALLATION SITE:
●
DO NOT install the unit where it may come into contact with combustible materials. A minimum of 24
inches clearance must be maintained between combustible materials and the hot water heater and the
outlet hot water pipe.
●
DO install the unit out of the reach of children to avoid injury or tampering with the water temperature
setting. The hot water outlet pipe can become very hot and should not be touched.
●
DO NOT install the unit in a location where it might come into contact with water, excess dust, high
humidity, or any other form of moisture. Do not install the unit under water pipes or air conditioning
lines, as they may leak or drip condensation onto the water heater.
●
DO NOT install the water heater above electrical boxes or junctions.
4 / 25
SELECTING A LOCATION FOR INSTALLATION