EcoSmart EL100 Installation, Operation And Maintanance Manual

Manual is about: ELECTRIC SERIES

Summary of EL100

  • Page 1

    Electric series installer: leave this manual with the appliance. Consumer: retain this manual for future reference. Installation, operation and maintenance manual el120 98.95kg, 218.15lbs el100 88.75kg, 195.66lbs el40 44kg, 97lbs el80 69.15kg, 152.34 lbs el60 55.65kg, 122.69lbs please read these ins...

  • Page 2

    Www.Ecosmartfire.Com english warning: improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. Refer to this manual. For assistance or additional information, consult a qualified installer. Caution: do not expose the heater to the elements (such as r...

  • Page 3

    © copyright 2004 - 2017 ecosmart inc. All rights reserved. V02jn17 power data product guide box contents el40 el60 el80 el100 el120 volts/hz amps ac 120v/60hz 15 amps ac 120v/60hz 15 amps ac 120v/60hz 15 amps ac 120v/60hz 15 amps ac 120v/60hz 15 amps heater ac 120v/60hz 750w/1500w ac 120v/60hz 750w/...

  • Page 4

    Www.Ecosmartfire.Com english caution: do not locate in a moist room such as a bathroom or laundry room. Caution: wear gloves and safety glasses for protection during installation and mainte-nance. Installation warning: if the information in these instructions is not followed exactly, a fire or explo...

  • Page 5

    © copyright 2004 - 2017 ecosmart inc. All rights reserved. V02jn17 2. Install l metal nailing flanges 3. Connect hard wire to the terminal block according to the diagram below. Choose any connector type according to local building code. 1. Prepare the framed opening using wood or metal studs accordi...

  • Page 6

    Www.Ecosmartfire.Com english optional installations installing the wired touch control 1. Locate and remove the access door on the rear right side of the fire unit. 2. Locate the wired touch control directly inside the access panel. Pull the touch control through the access panel and replace the acc...

  • Page 7

    © copyright 2004 - 2017 ecosmart inc. All rights reserved. V02jn17 heat operation installing optional log set 1. Remove the inner glass panel by first removing the 2 screws in the finger pull tabs (finger pull tabs are located on the top of the glass panel.) tilt the glass face down about 45 degrees...

  • Page 8

    Www.Ecosmartfire.Com english maintenance item photo description esf.1.El.P.Pcb electric printed circuit board esf.1.El.P.Lcd electric lcd touch control esf.1.El.P.Rem.Irc electric remote control ir receiver esf.1.El.P.Tra electric transformer esf.1.El.P.Hf.Rh electric right hand heater fan esf.1.El....

  • Page 9

    © copyright 2004 - 2017 ecosmart inc. All rights reserved. V02jn17 maintenance item photo description esf.1.El.P.Mdt40 electric metal deco trim 40 esf.1.El.P.Mdt60 electric metal deco trim 60 esf.1.El.P.Mdt80 electric metal deco trim 80 esf.1.El.P.Mdt100 electric metal deco trim 100 esf.1.El.P.Mdt12...

  • Page 10

    Www.Ecosmartfire.Com english maintenance problem possible cause corrective action flame is not visible when unit is turned on a. Wiring is loose a. Disconnect unit from power source and inspect for loose connections b. Motherboard is defective b. Replace motherboard fireplace lights up but there is ...

  • Page 11

    © copyright 2004 - 2017 ecosmart inc. All rights reserved. V02jn17 maintenance cleaning and maintenance instructions there is very little maintenance involved with your electric fireplace. Please follow the few points below: • on a semi-annual basis unplug the machine from it’s power source and wait...

  • Page 12

    Ecosmart inc. 5875 green valley circle, suite 100 culver city, ca 90230 p + 1 (888) 590.3335 e info@ecosmartfire.Com v02jn17.