Ecosy+ Ottawa 5kw Installation And Operating Instructions Manual - page 2
2
INTRODUCTION
Wood-burning Stove
Item No.: Ottawa 5kw
Size: W390XD330XH560MM
SAFETY
Safety is the most important consideration when using and installing your stove. If not installed
and used correctly, a house fire could result. Installation must comply with relevant national
and local Building Regulations and fire safety standards.
IN THE EVENT OF A CHIMNEY FIRE, EVACUATE THE PROPERTY AND CALL THE EMERGENCY
SERVICES.
Your stove will be heavy and care needs to be taken when lifting - 2 people will normally be
required to lift.
UNPACKING
Your stove will have several of its components stored inside the stove itself for transportation.
Take the legs out “cast iron stove only” and attach them one at a time to the underside of the
stove – it may help to sit the stove on some sturdy blocks of wood or bricks whilst you do this.
Do NOT use a wrench to tighten any bolts, they should be hand tight
only – cast iron is relatively brittle and can crack if over-tightened.
Do NOT drag the stove on its legs – it must be carefully lifted into place.
The flue spigot can also be bolted to the flue outlet – the stove has two options for flue outlet –
one on the top and one at the rear. - Most people use the top outlet – in this case, remove the
blanking plate at the top and secure to the rear outlet instead, but depending on where you
intend to position the stove in relation to your chimney, you may wish to use the rear outlet.
Inside the stove will also be an ash-pan which sits underneath the grate, and will require
regular emptying. You will also find a detachable tool for removal of the ash-pan.
You will also find a glove which must be used when opening the door or when adjusting air
vents when the fire is hot.
Baffle Plate
The baffle plate sits above the rear cast iron fire brick and comes to rest just above the top air
flow control. The end of the plate with rectangle holes cut in the end sits towards the front of
the unit.