Ecotec STC Operating Instructions Manual

Summary of STC

  • Page 1

    Operating instructions for stc battery charger.

  • Page 2: General  Safety

    General safety the charger may only be used for the specified battery types . This battery charger is supplied with pre-set charging curves that are adapted for the battery types listed in figure 1. Always contact the battery manufacturer to verify that the charging curve is appropriate. Hydrogen ga...

  • Page 3: Installation

    Installation initial installation the ac input source to which the charger is to be connected must be capable of supplying the current specified on the charger nameplate. Avoid the use of extension cords with the charger. The use of an improper extension cord could result in a risk of fire or electr...

  • Page 4: Figure 1

    Battery charger application the stc charger is intended for use in single shift and other light duty applications. Depending on battery capacity, charging can last from 10-16 hrs. Battery capacity ranges for each model are listed below: charger model output voltage max output amps battery size range...

  • Page 5

    Operation charging connecting a battery 1 check that the battery charger is turned off and the front panel switch is in the off position. All indicator lights should be off. 2 check the charger output cables and connector to ensure there is no visible damage. 3 connect the battery to the battery cha...

  • Page 6

    Disconnecting a battery 1 turn off the charger. Set the front panel switch to the off position. 2 disconnect the battery from the battery charger maintenance may only be performed by qualified personnel. Troubleshooting may only be performed by qualified personnel. Safety shutoff charging can be ter...

  • Page 7: Charger Warranty

    Charger warranty ecotec warrants that each new and unused pac800 battery charger (the “product”) manufactured and supplied with good workmanship is free from any known mechanical defect, provided that; (a) the product is installed and operated in accordance with the accepted industrial standards and...

  • Page 8

    Warranty terms and conditions, continued repair of modified equipment. Except as authorized in writing the warranty specified does not cover any equipment that has been repaired by any party other than ecotec or its authorized agents. Except as authorized in writing the warranty specified does not c...