Summary of Vectra
Page 1
071515 ® setup guide *esl integration requires reeflink vectra centrifugal pump tm.
Page 2
Customer support ...................... 1 inside the box ............................ 2 maintenance ............................... 3 installing the vectra™ ................ 4 plumbing the vectra™ ................ 5 installing the driver .................... 8 the vectra™ driver .......................
Page 3
2 3 inside the box vectra pump power supply quickcouple fittings driver power cord driver bracket your vectra centrifugal pump is designed to operate optimally with little attention after initial setup; however, due to the harsh conditions of a saltwater aquarium and resulting buildup of algae and o...
Page 4
Submersed b inline a installing the vectra ™ plumbing the vectra ™ step 1: adjust vectra head position (optional) • it is possible to rotate the head of the vectra to optimize for plumbing by removing all four hex bolts and rotating the head as shown below. 1. 2. 4. 3. Inline/submersed • the vectra ...
Page 5
6 7 using the quickcouple connector • installation of the connector requires the correct size plumbing and abs cement. • slide the union collar on to the pipe with the thread side pointing down. • apply abs cement to the inside of the union coupling and slide on to the bottom of the pipe. Make sure ...
Page 6
Installing the driver step 3: connect to pump and plug in driver step 1: choose driver location step 2: mount bracket and install driver (optional) always use a drip loop. Any water damage will not be covered under warranty. Installation requires use of a phillips head screwdriver. Please make sure ...
Page 7
The vectra tm driver operation configuration set button mode button wireless indicator led strip option/power button battery backup input pump cable slot power input accessory port control dial using the vectra driver watch the video: ecote.Ch/vectradriver + + + the default configuration of the pump...
Page 8
Return pump modes return pump calibration it is highly recommended to watch the calibration video before attempting to calibrate your vectra. This flow chart illustrates the general actions taken to achieve calibration with the vectra controller, for more detailed instructions please watch the video...
Page 9
Lagoonal random mode simulates a low-energy lagoon environment. It is indicated by a yellow control dial and the third and fourth leds illuminated. The control dial is used to set the maximum speed of this mode. The speed of the pump is changed slowly to recreate the gentle currents of a lagoon. Fee...
Page 10
Vectra tm with ecosmart live tm the vectra pump has even more capabilities and control available through ecosmart live & reeflink. To learn more visit: www.Ecosmartlive.Com 16 17 wifi wifi computers, mobile devices vectra, radion lights vortech pumps unlock additional vectra features ecosmart live r...
Page 11
Ecotech marine warrants to the original purchaser only that the vectra centrifugal pump will be free from defects in material and workmanship under normal use for a period of (1) year from the date of original purchase if the product is installed and used properly and consistent with the user manual...
Page 12
21 20 • non-immersible parts carry an ingress protection rating of ipx0 and must not be immersed in water. • danger: to avoid possible electrical shock, special care should be taken since water is employed in the use of aquarium equipment. • do not attempt repairs yourself; return the appliance to t...