Summary of Deebot D58
Page 1
D58 user guide robot vacuum cleaner.
Page 3
Thanks for purchasing products hope you can enjoy it thanks again for your choice! Patented . ! Robot vacuum cleaner.
Page 4
1. Safety instruction........................... User guide............................ . ...... 9. Remote control..... . ............. Power supply for the product........ ...... The spectrum of product use........ ...... Use of remote control notes before cleaning........ ............... 10.Virtua...
Page 5
1. Safety instruction 3 the user guide please conform to the basic safety precautions as follows: ● read the content in this user guide carefully and install the robot according to the detailed instructions. ● safekeeping this guide. If you transfer this machine to another person, please make sure a...
Page 6
4 the spectrum of the product use ● this robot is applicable to domestic sweeping, including wooden floor, rubber floor, ceramic tile, linoleum and medium or short-haired carpet however, it is inapplicable to long-haired carpet. ● it can not be used for the floor as below: ---- have water on the sur...
Page 7
5 notes before cleaning ● take extra care of the robot when the first it works. Please remove the obstacles when it is beyond the robot. Try to avoid the situation that the robot stops working. ● make precautions to solve the problem which may make the cleaning in trouble, such as: keep the easily k...
Page 8
6 ● take good care of the product and keep it beyond child and people who can not judge danger nearby. Extra attention should be paid when it working. ● you should get the person inside the room know that the machine is working, in order to avoid man-made damage like tripping. ● do not take robot as...
Page 9
2. C o n t e n t 7 host charging block virtual wall battery for virtual wall user guide border tape magnetic adding tool side brush roll brush clean-up gadget remote control battery for remote control spot edge auto return intensive d58 user guide robot vacuum cleaner e n j o y s m a r t e r l i f e...
Page 10
8 dc14.4v ac220-240v dc17.5v 50hz 30w 0.8a dc3v dc3v ≤5meters 30w 0.25meter/second 0.7l ≤62db about 3 hours about 60 minutes 2 120-150m 330×330×100mm 2.8kg the host the charging block remote control virtual wall working voltage in-put voltage rated out-put voltage rated frequency rated power rated o...
Page 11
3. Name of parts 9 control button wind gate rotating side brush up-ground height sensor all-round wheel suspended driving wheel rubber scraper dust sensor dust sensor dust box dust box handle ash exit antibacterial sponge filter lock of dust box charging and alarm open button of upper cover docking ...
Page 12
Mode 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 1. Power 8. Intensive cleaning mode 15. Appointment time setting 20. Tip for trapped 2. Model selection 9. Automatic cleaning mode 16. Time adjust button 21. Tip for driving wheel suspend 3. On/pause 10. Operation status 17. Current time set...
Page 13
Tangle the power cord on the pothook and do not scatter it besides the block or hold it under the base, in case that robot would get impeded when it turns back. 1.5 m 0. 5 m 0. 5 m there should not be any object at least 1.5 meter in front of the charging block. Besides, anything with strong reflect...
Page 14
● press the key on host and get power supply. There would be a short music tip and at the same time lcd lights for roughly 2 second and goes off. Then press key to start robot . ● 5. Power on/ pause/ power off ● press key, it can pause the operation of robot and keep it stay where it is. ● press key...
Page 15
10 put the robot on the charging block and keep it charging after finishing house cleaning. Do not keep the robot on pause status for long time, because under pause, the full charged battery can only last for around 20 hours. We suggest you to turn it off when you do not want it to work. Tips : pres...
Page 16
Route description: would run along it, like wall, to clean until it meets obstacle and change the former route. Under this mode, once the robot detects objects, it under this status, robot helps to remove the corner of wall, table, sofa and bed where it is beyond the mode of automatic cleaning. The ...
Page 17
7 .Automatically charging ？ ?? ● ● ● ● ● ● when it finishes cleaning or there is low battery, it would seek charger in same route as automatic cleaning. To make it easy for robot to search for charging block, you need to put the block back to the wall and make sure there is no obstacle within 1.5 me...
Page 18
Tips: second time setting current time setting selection scope: hour is between 0 and 23, minute is between 0-59. Under normal circumstance, time display on lcd shows current time. Tips : selection scope: hour is between 0 and 23, minute is between 0-59. Under normal circumstance, time display on lc...
Page 19
9. Remote control note tips: tips : when power is off, robot will not start work on appointment time .If you have already set appointment time cleaning, please turn on the robot and keep it on standby status， even though it is not operating. Try to make it stay at the charger and check whether it is...
Page 20
Automatic cleaning mode/ border cleaning mode/ fixed point cleaning mode/ intensive cleaning mode/ go back charging mode 10. Virtual wall tips: use of remote control you can control the robot via remote control. Drive robot to appointed area via using direction control button. Choose certain working...
Page 21
M 2 note: when you use virtual wall, please face marked ecovacs to the block area you expect. Put virtual wall outside of the room you want to block to get best effect. The system would cancel virtual wall after it is set for two hours in order to save battery. As a result, every time the robot star...
Page 22
11. Border tape border tape instruction 20 border tape is used to confine the cleaning area. Deebot will not proceed beyond the border, allowing deebot to clean a designated area. Clean the area where you plan to paste the border tape with a dry cloth. Unroll the border tape and cut the length accor...
Page 23
1 1 12. Day-to-day storage 13. Maintenance you should keep robot stay at charger even though it finishes charging and cleaning task, because it will change to small currency to supplement charging. Charge the robot until full battery and put it back to the package if you do not need to use it for lo...
Page 24
Tips ： if the dust box is not placed back or not properly placed, robot will alarm and show red indicator on lcd. 1 2 1 3 1 4 1 5 1 6 1 7 hold the handle of dust box and lift it to take out. In order to avoid dust leaking, lift the suction up when you take out dust box. Please mind your speed doing ...
Page 25
1 1 3 4 4 4 5 1 2 8 1 9 1 2 6 7 2 main brush cleaning tips: clean the main brush after it has operated for 4 or 5 recycles. Undo the screw fixed on the main brush. Remove the hair and dust which is in-between the belt. Put the main brush back to the host and take care of the anastomosis of belt. Fix...
Page 26
Note： note: side brush cleaning replace sidebrush driving wheel cleaning up-ground height sensor cleaning please replace the side brush when it is destroyed. Please remove the screws, and take out the side brush. Please push the new side brush into the correct position. Tight the screws. Side brush ...
Page 27
14. Alarm function note: dust sensor cleaning the dust sensor is located at the front of dust entrance. It is able to detect the concentration of dust so that it can choose efficient mode to work. We suggest you to clean dust sensor once you clean dust box to improve work efficiency. 1. Turn off pow...
Page 28
4 3 2 1 15. Common failure no. Problem solution robot keeps proceeding or moving backward once power is on. Turn off the power. 1. Check if there is dust on up-ground height sensor, which cause robot to make wrong signal. Use half dry cloth to clean it. Buffer collision is out of control. Put your h...
Page 29
5 16. Other problems there is much noise when the robot works. 1. Check whether the suction of main brush is blocked. 2. Examine and clean the main brush(at both ends). 3. Examine and clean the side brush. Turn off the power supply, and then take out of dust box. After removing the garbage, overturn...
Page 30
10 why does robot fail to start cleaning on side brush can remove dust along bottom appointment time? Edge efficiently; there would be dust beyond robot in the tiny area formed by two walls answer: a.Confirm whether there is much which need to be removed by hand. Remaining battery. Appointment timin...
Page 31
21 how does main brush avoid being tangled if the procedures above still do not make by power cord? It work, please contact our after-sales service. Answer: robot is probably get tangled by the wire scattered on the floor when it is operating. At that time, robot will try to turn back to get rid of ...
Page 32
Enjoy smar ter life! D58-000im201101.