1 how to install, operate and maintain your ecowater series 4000 dual demand ® part no. 7122633 (rev. C 10/18/02) printed in u.S.A..
2.
3.
4.
5.
6 introduction screen (for brine tubing).
7 planning installation special plumbing items included are 1" o.D. Copper. Water meter nut flare tube gasket, 5/32" thk..
8.
9 fig.4 installation a. As shown, place oĆring seals (4) onto the ends of both manifolds. If needed, lubricate the oĆrings with high quality silicone grease. Tor and 2 thick (5/32") gaskets as shown in figure 4, assemble the water meter to the outlet manifold. Be sure to tighten all conĆ nections. 5...
10
11 note: a small screen is available (see parts section) to install in the top end of the brine tubing. It helps protect plugging on the botĆ tom side of the nozzle fill flow plug (fig. 7). Use a blunt tool to push it into the tubing. Screen brine tubing 9 . 10 ..
12.
13.
14.
15.
16.
17.
18.
19.
20
21.
22.
23.
24.
25.
26.
27.
28 repair parts 30 parts list on page 29 30 40 10 11 41.
29 repair parts list key no. Part number description of part 1 7161807 tubing, 5/16" x 20' (not included with softener) 7161768 tubing, 5/16" x 100' (not included with softener) 2 7056612 tee fitting (includes 3 of key no. 3) 3 9003201 compression nut (3 req'd) 4 7113016 tubing assembly, brine valve...
30 4 4 10 11 12 13 14 15 16 17 18 19 parts list on page 31 repair parts.
31 repair parts key no. Part number description of part 1 7116713 clip (4) 2 7163744 manifold, inlet 3 7163760 manifold, outlet 4 7174305 gasket, 5/32" thick (3 req'd) 5 1258500 adaptor fitting 6 water meter kit (includes following) 7095569 sensor housing 9000803 oĆring seal, 3/8" x 1/2" 7119787 tur...