EcoWater ERO-375 Owner's Manual - page 13
13
FIGURE 10
CONNECT button
(push with ball point pen)
STATUS light
Hydrolink Plus
®
RO Module
CONNECTING THE HYDROLINK PLUS
®
RO MODULE TO WI-FI
(HERO-375Plus Only)
If your device does not appear in the list
review step 1 and tap the refresh button.
The CONNECT button on the Hydrolink Plus
®
RO
module (see Figure 10) is used to:
=
Check battery and connection status
=
Place unit in Connect Mode ready to connect to Wi-Fi
CHECKING BATTERIES & CONNECTION
To check battery and connection status, press and release
the CONNECT button (do not hold longer than 1 sec-
ond). The status is then displayed for 3 seconds by the
STATUS light (see Figure 10), as follows:
LED
Indication
Status
Green
for 3 sec.
Batteries are good. The system is connect-
ed to the cloud and registered.
Amber
for 3 sec.
Batteries are good. The system is regis-
tered, but NOT currently connected to the
cloud (the last attempt to share data failed).
Alternating
Green/Amber
Batteries are good.
The system is NOT registered.
Red (3 sec.)
Batteries are low.
No light
Batteries are dead.
CONNECT MODE
To place the Hydrolink Plus
®
RO module into Connect
Mode, ready to connect to Wi-Fi, press and hold for 3
seconds the CONNECT button. If battery strength is
sufficient to place the unit into Connect Mode, the
STATUS light begins flashing amber, 1 second on and
1 second off. The unit will remain in Connect Mode for
2 minutes, waiting for you to connect it to the cloud via
the home’s wireless router. When a connection has been
made, the STATUS light turns amber, and it will then
turn green after the system has been registered:
LED
Indication
Status
Red (3 sec.)
Batteries are too low to place unit
into Connect Mode.
Flashing Amber
(up to 2 minutes)
System is in Connect Mode, wait-
ing to be connected to the cloud
via the home’s wireless router.
Amber after Connect
Mode (up to 1 min.)
System successfully connected to
the cloud, but is not yet registered.
Green for 1 min.
after Connect Mode
System has been successfully con-
nected and registered.
No light after 2 min.
in Connect Mode
System not connected to the cloud
or registered.
While the unit is in Connect Mode (LED flashing
amber), pressing the CONNECT button again will not
cancel Connect Mode. Also, you will not be able to use
the CONNECT button during the 1 minute the LED is
green following a successful connection and registration.
CONNECTING TO WI-FI USING THE APP
1. DETECT DEVICE / CONNECT TO DEVICE
Make sure that you have downloaded the most recent
version of the app from your app store: “EcoWater
Systems Wi-Fi Smart Device Manager” (iOS) or
“EcoWater Systems Wi-Fi Manager” (Android).
Open the app. Place the Hydrolink Plus
®
RO module
into Connect Mode (see previous section). Within 2
minutes, select “Add a System” under “My Devices”.
iOS
Android
Android: Locate the line
beginning with “SHERO”
in the list of Wi-Fi
devices detected. If you
do not see “SHERO”,
make sure that the Hydro -
link Plus
®
RO Module is
in Connect Mode. Select
the “SHERO” line and
click “NEXT”.
iOS: Go to your “Settings”
and display the wireless
(Wi-Fi) networks in range.
Locate the line beginning
with “SHERO” in the list
of networks detected. If
you do not see “SHERO”,
make sure that the Hydro -
link Plus
®
RO Module is in
Connect Mode. Select the
“SHERO” line and click
“NEXT”.